wandboard: Avoid calling setup_display() from SPL code

There is no need call setup_display() from SPL code, so move it to
board_init(), which executes only in U-Boot proper.

Reported-by: Stefano Babic <sbabic@denx.de>
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Reviewed-by: Stefano Babic <sbabic@denx.de>

diff --git a/board/wandboard/wandboard.c b/board/wandboard/wandboard.c
index adfcf48..dde4988 100644 (file)
--- a/board/wandboard/wandboard.c
+++ b/board/wandboard/wandboard.c
@@ -376,9 +376,6 @@ int board_eth_init(bd_t *bis)
 int board_early_init_f(void)
 {
        setup_iomux_uart();
-#if defined(CONFIG_VIDEO_IPUV3)
-       setup_display();
-#endif
 #ifdef CONFIG_SATA
        /* Only mx6q wandboard has SATA */
        if (is_cpu_type(MXC_CPU_MX6Q))
@@ -448,6 +445,8 @@ int board_init(void)
                setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6q_i2c2_pad_info);
        else
                setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6dl_i2c2_pad_info);
+
+       setup_display();
 #endif
 
        return 0;