int wl1251_boot_run_firmware(struct wl1251 *wl)
{
int loop, ret;
- u32 chip_id, interrupt;
+ u32 chip_id, acx_intr;
wl1251_boot_set_ecpu_ctrl(wl, ECPU_CONTROL_HALT);
loop = 0;
while (loop++ < INIT_LOOP) {
udelay(INIT_LOOP_DELAY);
- interrupt = wl1251_reg_read32(wl, ACX_REG_INTERRUPT_NO_CLEAR);
+ acx_intr = wl1251_reg_read32(wl, ACX_REG_INTERRUPT_NO_CLEAR);
- if (interrupt == 0xffffffff) {
+ if (acx_intr == 0xffffffff) {
wl1251_error("error reading hardware complete "
"init indication");
return -EIO;
}
/* check that ACX_INTR_INIT_COMPLETE is enabled */
- else if (interrupt & WL1251_ACX_INTR_INIT_COMPLETE) {
+ else if (acx_intr & WL1251_ACX_INTR_INIT_COMPLETE) {
wl1251_reg_write32(wl, ACX_REG_INTERRUPT_ACK,
WL1251_ACX_INTR_INIT_COMPLETE);
break;
#define WL1251_SCAN_NUM_PROBES 3
struct wl1251_scan_parameters {
- u32 rx_config_options;
- u32 rx_filter_options;
+ __le32 rx_config_options;
+ __le32 rx_filter_options;
/*
* Scan options:
* bit 2: voice mode, 0 for normal scan.
* bit 3: scan priority, 1 for high priority.
*/
- u16 scan_options;
+ __le16 scan_options;
/* Number of channels to scan */
u8 num_channels;
u8 num_probe_requests;
/* Rate and modulation for probe requests */
- u16 tx_rate;
+ __le16 tx_rate;
u8 tid_trigger;
u8 ssid_len;
} __attribute__ ((packed));
struct wl1251_scan_ch_parameters {
- u32 min_duration; /* in TU */
- u32 max_duration; /* in TU */
+ __le32 min_duration; /* in TU */
+ __le32 max_duration; /* in TU */
u32 bssid_lsb;
u16 bssid_msb;
frag_threshold = IEEE80211_MAX_FRAG_THRESHOLD;
tx_hdr->frag_threshold = cpu_to_le16(frag_threshold);
- payload_len = tx_hdr->length + MAX_MSDU_SECURITY_LENGTH;
+ payload_len = le16_to_cpu(tx_hdr->length) + MAX_MSDU_SECURITY_LENGTH;
if (payload_len > frag_threshold) {
mem_blocks_per_frag =
if (control->control.hw_key &&
control->control.hw_key->alg == ALG_TKIP) {
int hdrlen;
- u16 fc;
+ __le16 fc;
+ u16 length;
u8 *pos;
- fc = *(u16 *)(skb->data + sizeof(*tx_hdr));
- tx_hdr->length += WL1251_TKIP_IV_SPACE;
+ fc = *(__le16 *)(skb->data + sizeof(*tx_hdr));
+ length = le16_to_cpu(tx_hdr->length) + WL1251_TKIP_IV_SPACE;
+ tx_hdr->length = cpu_to_le16(length);
hdrlen = ieee80211_hdrlen(fc);
struct tx_double_buffer_desc {
/* Length of payload, including headers. */
- u16 length;
+ __le16 length;
/*
* A bit mask that specifies the initial rate to be used
* 0x0800 - 48Mbits
* 0x1000 - 54Mbits
*/
- u16 rate;
+ __le16 rate;
/* Time in us that a packet can spend in the target */
- u32 expiry_time;
+ __le32 expiry_time;
/* index of the TX queue used for this packet */
u8 xmit_queue;
* The FW should cut the packet into fragments
* of this size.
*/
- u16 frag_threshold;
+ __le16 frag_threshold;
/* Numbers of HW queue blocks to be allocated */
u8 num_mem_blocks;