jme->fpgaver = (chipmode & CM_FPGAVER_MASK) >> CM_FPGAVER_SHIFT;
jme->chiprev = (chipmode & CM_CHIPREV_MASK) >> CM_CHIPREV_SHIFT;
+ jme->chip_main_rev = jme->chiprev & 0xF;
+ jme->chip_sub_rev = (jme->chiprev >> 4) & 0xF;
}
static const struct net_device_ops jme_netdev_ops = {
jme_clear_pm(jme);
jme_set_phyfifoa(jme);
- pci_read_config_byte(pdev, PCI_REVISION_ID, &jme->rev);
+ pci_read_config_byte(pdev, PCI_REVISION_ID, &jme->pcirev);
if (!jme->fpgaver)
jme_phy_init(jme);
jme_phy_off(jme);
goto err_out_unmap;
}
- netif_info(jme, probe, jme->dev, "%s%s ver:%x rev:%x macaddr:%pM\n",
+ netif_info(jme, probe, jme->dev, "%s%s chiprev:%x pcirev:%x macaddr:%pM\n",
(jme->pdev->device == PCI_DEVICE_ID_JMICRON_JMC250) ?
"JMC250 Gigabit Ethernet" :
(jme->pdev->device == PCI_DEVICE_ID_JMICRON_JMC260) ?
"JMC260 Fast Ethernet" : "Unknown",
(jme->fpgaver != 0) ? " (FPGA)" : "",
(jme->fpgaver != 0) ? jme->fpgaver : jme->chiprev,
- jme->rev, netdev->dev_addr);
+ jme->pcirev, netdev->dev_addr);
return 0;
u32 rx_ring_mask;
u8 mrrs;
unsigned int fpgaver;
- unsigned int chiprev;
- u8 rev;
+ u8 chiprev;
+ u8 chip_main_rev;
+ u8 chip_sub_rev;
+ u8 pcirev;
u32 msg_enable;
struct ethtool_cmd old_ecmd;
unsigned int old_mtu;
/*
* Workaround
*/
-static inline int is_buggy250(unsigned short device, unsigned int chiprev)
+static inline int is_buggy250(unsigned short device, u8 chiprev)
{
return device == PCI_DEVICE_ID_JMICRON_JMC250 && chiprev == 0x11;
}