USB: isp1362: fix build failure on ARM systems via irq_flags cleanup

There was some left over #ifdef ARM logic that is outdated but no one
really noticed.  So instead of relying on this tricky logic, properly
load and utilize the platform irq_flags resources.

Reported-by: Ben Hutchings <ben@decadent.org.uk>
Signed-off-by: Lothar Wassmann <LW@KARO-electronics.de>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

diff --git a/drivers/usb/host/isp1362-hcd.c b/drivers/usb/host/isp1362-hcd.c
index 8d31044..4297165 100644 (file)
--- a/drivers/usb/host/isp1362-hcd.c
+++ b/drivers/usb/host/isp1362-hcd.c
@@ -2697,6 +2697,8 @@ static int __init isp1362_probe(struct platform_device *pdev)
        void __iomem *data_reg;
        int irq;
        int retval = 0;
+       struct resource *irq_res;
+       unsigned int irq_flags = 0;
 
        /* basic sanity checks first.  board-specific init logic should
         * have initialized this the three resources and probably board
@@ -2710,11 +2712,12 @@ static int __init isp1362_probe(struct platform_device *pdev)
 
        data = platform_get_resource(pdev, IORESOURCE_MEM, 0);
        addr = platform_get_resource(pdev, IORESOURCE_MEM, 1);
-       irq = platform_get_irq(pdev, 0);
-       if (!addr || !data || irq < 0) {
+       irq_res = platform_get_resource(pdev, IORESOURCE_IRQ, 0);
+       if (!addr || !data || !irq_res) {
                retval = -ENODEV;
                goto err1;
        }
+       irq = irq_res->start;
 
 #ifdef CONFIG_USB_HCD_DMA
        if (pdev->dev.dma_mask) {
@@ -2781,12 +2784,16 @@ static int __init isp1362_probe(struct platform_device *pdev)
        }
 #endif
 
-#ifdef CONFIG_ARM
-       if (isp1362_hcd->board)
-               set_irq_type(irq, isp1362_hcd->board->int_act_high ? IRQT_RISING : IRQT_FALLING);
-#endif
+       if (irq_res->flags & IORESOURCE_IRQ_HIGHEDGE)
+               irq_flags |= IRQF_TRIGGER_RISING;
+       if (irq_res->flags & IORESOURCE_IRQ_LOWEDGE)
+               irq_flags |= IRQF_TRIGGER_FALLING;
+       if (irq_res->flags & IORESOURCE_IRQ_HIGHLEVEL)
+               irq_flags |= IRQF_TRIGGER_HIGH;
+       if (irq_res->flags & IORESOURCE_IRQ_LOWLEVEL)
+               irq_flags |= IRQF_TRIGGER_LOW;
 
-       retval = usb_add_hcd(hcd, irq, IRQF_TRIGGER_LOW | IRQF_DISABLED | IRQF_SHARED);
+       retval = usb_add_hcd(hcd, irq, irq_flags | IRQF_DISABLED | IRQF_SHARED);
        if (retval != 0)
                goto err6;
        pr_info("%s, irq %d\n", hcd->product_desc, irq);