The device tree provides information about which regulators should be
on at boot, or always on. Use this to set them up automatically.
Signed-off-by: Simon Glass <sjg@chromium.org>
Tested-by: Przemyslaw Marczak <p.marczak@samsung.com>
Acked-by: Przemyslaw Marczak <p.marczak@samsung.com>
return 0;
}
+int regulators_enable_boot_on(bool verbose)
+{
+ struct udevice *dev;
+ struct uclass *uc;
+ int ret;
+
+ ret = uclass_get(UCLASS_REGULATOR, &uc);
+ if (ret)
+ return ret;
+ for (uclass_first_device(UCLASS_REGULATOR, &dev);
+ dev && !ret;
+ uclass_next_device(&dev)) {
+ ret = regulator_autoset(dev);
+ if (ret == -EMEDIUMTYPE)
+ continue;
+ if (verbose)
+ regulator_show(dev, ret);
+ }
+
+ return ret;
+}
+
UCLASS_DRIVER(regulator) = {
.id = UCLASS_REGULATOR,
.name = "regulator",
int regulator_set_mode(struct udevice *dev, int mode_id);
/**
+ * regulators_enable_boot_on() - enable regulators needed for boot
+ *
+ * This enables all regulators which are marked to be on at boot time. This
+ * only works for regulators which don't have a range for voltage/current,
+ * since in that case it is not possible to know which value to use.
+ *
+ * This effectively calls regulator_autoset() for every regulator.
+ */
+int regulators_enable_boot_on(bool verbose);
+
+/**
* regulator_autoset: setup the voltage/current on a regulator
*
* The setup depends on constraints found in device's uclass's platform data