[SCSI] qla2xxx: Correct LED scheme definition.

Original implementation used an overloaded bit in the EFI
parameters.  The correct bit is BIT_4 of the special_options
section of NVRAM.

Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>

diff --git a/drivers/scsi/qla2xxx/qla_def.h b/drivers/scsi/qla2xxx/qla_def.h
index cdef86e..b7f82b7 100644 (file)
--- a/drivers/scsi/qla2xxx/qla_def.h
+++ b/drivers/scsi/qla2xxx/qla_def.h
@@ -914,7 +914,7 @@ typedef struct {
         * MSB BIT 1 =
         * MSB BIT 2 =
         * MSB BIT 3 =
-        * MSB BIT 4 =
+        * MSB BIT 4 = LED mode
         * MSB BIT 5 = enable 50 ohm termination
         * MSB BIT 6 = Data Rate (2300 only)
         * MSB BIT 7 = Data Rate (2300 only)
@@ -1036,7 +1036,7 @@ typedef struct {
         * MSB BIT 1 =
         * MSB BIT 2 =
         * MSB BIT 3 =
-        * MSB BIT 4 =
+        * MSB BIT 4 = LED mode
         * MSB BIT 5 = enable 50 ohm termination
         * MSB BIT 6 = Data Rate (2300 only)
         * MSB BIT 7 = Data Rate (2300 only)

diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index d12255f..c619583 100644 (file)
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -1564,7 +1564,7 @@ qla2x00_nvram_config(scsi_qla_host_t *ha)
        ha->flags.enable_lip_reset = ((nv->host_p[1] & BIT_1) ? 1 : 0);
        ha->flags.enable_lip_full_login = ((nv->host_p[1] & BIT_2) ? 1 : 0);
        ha->flags.enable_target_reset = ((nv->host_p[1] & BIT_3) ? 1 : 0);
-       ha->flags.enable_led_scheme = ((nv->efi_parameters & BIT_3) ? 1 : 0);
+       ha->flags.enable_led_scheme = (nv->special_options[1] & BIT_4) ? 1 : 0;
 
        ha->operating_mode =
            (icb->add_firmware_options[0] & (BIT_6 | BIT_5 | BIT_4)) >> 4;