--- /dev/null
+.. SPDX-License-Identifier: GPL-2.0-or-later
+
+Kernel driver sbrmi
+===================
+
+Supported hardware:
+
+ * Sideband Remote Management Interface (SB-RMI) compliant AMD SoC
+ device connected to the BMC via the APML.
+
+ Prefix: 'sbrmi'
+
+ Addresses scanned: This driver doesn't support address scanning.
+
+ To instantiate this driver on an AMD CPU with SB-RMI
+ support, the i2c bus number would be the bus connected from the board
+ management controller (BMC) to the CPU.
+ The SMBus address is really 7 bits. Some vendors and the SMBus
+ specification show the address as 8 bits, left justified with the R/W
+ bit as a write (0) making bit 0. Some vendors use only the 7 bits
+ to describe the address.
+ As mentioned in AMD's APML specification, The SB-RMI address is
+ normally 78h(0111 100W) or 3Ch(011 1100) for socket 0 and 70h(0111 000W)
+ or 38h(011 1000) for socket 1, but it could vary based on hardware
+ address select pins.
+
+ Datasheet: The SB-RMI interface and protocol along with the Advanced
+ Platform Management Link (APML) Specification is available
+ as part of the open source SoC register reference at:
+
+ https://www.amd.com/en/support/tech-docs?keyword=55898
+
+Author: Akshay Gupta <akshay.gupta@amd.com>
+
+Description
+-----------
+
+The APML provides a way to communicate with the SB Remote Management interface
+(SB-RMI) module from the external SMBus master that can be used to report socket
+power on AMD platforms using mailbox command and resembles a typical 8-pin remote
+power sensor's I2C interface to BMC.
+
+This driver implements current power with power cap and power cap max.
+
+sysfs-Interface
+---------------
+Power sensors can be queried and set via the standard ``hwmon`` interface
+on ``sysfs``, under the directory ``/sys/class/hwmon/hwmonX`` for some value
+of ``X`` (search for the ``X`` such that ``/sys/class/hwmon/hwmonX/name`` has
+content ``sbrmi``)
+
+================ ===== ========================================================
+Name Perm Description
+================ ===== ========================================================
+power1_input RO Current Power consumed
+power1_cap RW Power limit can be set between 0 and power1_cap_max
+power1_cap_max RO Maximum powerlimit calculated and reported by the SMU FW
+================ ===== ========================================================
+
+The following example show how the 'Power' attribute from the i2c-addresses
+can be monitored using the userspace utilities like ``sensors`` binary::
+
+ # sensors
+ sbrmi-i2c-1-38
+ Adapter: bcm2835 I2C adapter
+ power1: 61.00 W (cap = 225.00 W)
+
+ sbrmi-i2c-1-3c
+ Adapter: bcm2835 I2C adapter
+ power1: 28.39 W (cap = 224.77 W)
+ #
+
+Also, Below shows how get and set the values from sysfs entries individually::
+ # cat /sys/class/hwmon/hwmon1/power1_cap_max
+ 225000000
+
+ # echo 180000000 > /sys/class/hwmon/hwmon1/power1_cap
+ # cat /sys/class/hwmon/hwmon1/power1_cap
+ 180000000