serial: fsl_lpuart: Support common rs485 binding for RTS polarity

Invoke the ->rs485_config callback on probe to set UARTMODEM_TXRTSPOL
appropriately based on the UART's device properties.

This implicitly sets UARTMODEM_TXRTSE if rs485 was enabled in the device
properties, so drop the identical code from lpuart_probe().

It also fixes a bug:  If an unsupported rs485 property was specified
(rs485-rx-during-tx or rs485-rts-delay), the driver returns -ENOSYS
without performing any cleanup, in particular without calling
uart_remove_one_port() or clk_disable_unprepare(), thus leaking the
uart_port. But with the invocation of ->rs485_config, the unsupported
properties are now cleared in struct serial_rs485 and thus ignored.
It therefore seems sufficient to just log an error instead of bailing
out.

Cc: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Lukas Wunner <lukas@wunner.de>
Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index 38e76f9..8cf112f 100644 (file)
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -2208,21 +2208,14 @@ static int lpuart_probe(struct platform_device *pdev)
 
        uart_get_rs485_mode(&pdev->dev, &sport->port.rs485);
 
-       if (sport->port.rs485.flags & SER_RS485_RX_DURING_TX) {
+       if (sport->port.rs485.flags & SER_RS485_RX_DURING_TX)
                dev_err(&pdev->dev, "driver doesn't support RX during TX\n");
-               return -ENOSYS;
-       }
 
        if (sport->port.rs485.delay_rts_before_send ||
-           sport->port.rs485.delay_rts_after_send) {
+           sport->port.rs485.delay_rts_after_send)
                dev_err(&pdev->dev, "driver doesn't support RTS delays\n");
-               return -ENOSYS;
-       }
 
-       if (sport->port.rs485.flags & SER_RS485_ENABLED) {
-               sport->port.rs485.flags |= SER_RS485_RTS_ON_SEND;
-               writeb(UARTMODEM_TXRTSE, sport->port.membase + UARTMODEM);
-       }
+       lpuart_config_rs485(&sport->port, &sport->port.rs485);
 
        sport->dma_tx_chan = dma_request_slave_channel(sport->port.dev, "tx");
        if (!sport->dma_tx_chan)