T208XRDB only has one target T2080RDB. Use TARGET_T2080RDB in Kconfig
and clean up existing macros.
Signed-off-by: York Sun <york.sun@nxp.com>
select SUPPORT_SPL
select PHYS_64BIT
-config TARGET_T208XRDB
- bool "Support T208xRDB"
+config TARGET_T2080RDB
+ bool "Support T2080RDB"
select SUPPORT_SPL
select PHYS_64BIT
-if TARGET_T208XRDB
+if TARGET_T2080RDB
config SYS_BOARD
default "t208xrdb"
CONFIG_SPL_ENV_SUPPORT=y
CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
CONFIG_MPC85xx=y
-CONFIG_TARGET_T208XRDB=y
+CONFIG_TARGET_T2080RDB=y
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_SPL_ENV_SUPPORT=y
CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
CONFIG_MPC85xx=y
-CONFIG_TARGET_T208XRDB=y
+CONFIG_TARGET_T2080RDB=y
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_PPC=y
CONFIG_MPC85xx=y
-CONFIG_TARGET_T208XRDB=y
+CONFIG_TARGET_T2080RDB=y
# CONFIG_SYS_MALLOC_F is not set
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_SPL_SPI_FLASH_SUPPORT=y
CONFIG_SPL_SPI_SUPPORT=y
CONFIG_MPC85xx=y
-CONFIG_TARGET_T208XRDB=y
+CONFIG_TARGET_T2080RDB=y
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_PPC=y
CONFIG_MPC85xx=y
-CONFIG_TARGET_T208XRDB=y
+CONFIG_TARGET_T2080RDB=y
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_PPC=y
CONFIG_MPC85xx=y
-CONFIG_TARGET_T208XRDB=y
+CONFIG_TARGET_T2080RDB=y
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y