prefixes.
Enabled by default.
+\b \i\c{bnd} warns about ineffective use of the \c{BND} prefix when a relaxed
+form of jmp instruction becomes jmp short form.
+Enabled by default.
+
\b \i\c{error} causes warnings to be treated as errors. Disabled by
default.
and P6 instructions, FPU instructions, MMX instructions and even
undocumented instructions are all supported. The instruction may be
prefixed by \c{LOCK}, \c{REP}, \c{REPE}/\c{REPZ}, \c{REPNE}/\c{REPNZ},
-\c{XACQUIRE}/\c{XRELEASE} or \c{BND}, in the usual way. Explicit
+\c{XACQUIRE}/\c{XRELEASE} or \c{BND}/\c{NOBND}, in the usual way. Explicit
\I{address-size prefixes}address-size and \i{operand-size prefixes} \i\c{A16},
\i\c{A32}, \i\c{A64}, \i\c{O16} and \i\c{O32}, \i\c{O64} are provided - one example of their use
is given in \k{mixsize}. You can also use the name of a \I{segment
obnoxious, as the explicit form is pretty much the only one one wishes
to use.
-Currently, the only \c{DEFAULT} that is settable is whether or not
-registerless instructions in 64-bit mode are \c{RIP}-relative or not.
-By default, they are absolute unless overridden with the \i\c{REL}
+Currently, \c{DEFAULT} can set \c{REL} & \c{ABS} and \c{BND} & \c{NOBND}.
+
+\S{REL & ABS} \i\c{REL} & \i\c{ABS}: RIP-relative addressing
+
+This sets whether registerless instructions in 64-bit mode are \c{RIP}-relative
+or not. By default, they are absolute unless overridden with the \i\c{REL}
specifier (see \k{effaddr}). However, if \c{DEFAULT REL} is
specified, \c{REL} is default, unless overridden with the \c{ABS}
specifier, \e{except when used with an FS or GS segment override}.
\c{DEFAULT REL} is disabled with \c{DEFAULT ABS}.
+\S{BND & NOBND} \i\c{BND} & \i\c{NOBND}: \c{BND} prefix
+
+If \c{DEFAULT BND} is set, all bnd-prefix available instructions following
+this directive are prefixed with bnd. To override it, \c{NOBND} prefix can
+be used.
+
+\c DEFAULT BND
+\c call foo ; BND will be prefixed
+\c nobnd call foo ; BND will NOT be prefixed
+
+DEFAULT NOBND can disable DEFAULT BND and then \c{BND} prefix will be added
+only when explicitly specified in code.
+
\H{section} \i\c{SECTION} or \i\c{SEGMENT}: Changing and \i{Defining
Sections}