The Juno board features a standard compliant EHCI/OHCI USB host
controller pair, which we can just enable.
The platform data is taken from the device tree.
This allows to use USB mass storage (the only storage on a Juno r0)
for loading.
At least on my board USB seems a bit flaky, I need two "usb reset"
sequences after the "usb start" to detect an USB hard drive.
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Acked-by: Liviu Dudau <liviu.dudau@arm.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Simon Glass <sjg@chromium.org>
select DM_SERIAL
select ARM_PSCI_FW
select PSCI_RESET
select DM_SERIAL
select ARM_PSCI_FW
select PSCI_RESET
+ select DM
+ select BLK
+ select USB
+ select DM_USB
config TARGET_LS2080A_EMU
bool "Support ls2080a_emu"
config TARGET_LS2080A_EMU
bool "Support ls2080a_emu"
CONFIG_CMD_CACHE=y
# CONFIG_CMD_MISC is not set
CONFIG_CMD_UBI=y
CONFIG_CMD_CACHE=y
# CONFIG_CMD_MISC is not set
CONFIG_CMD_UBI=y
# CONFIG_ISO_PARTITION is not set
# CONFIG_EFI_PARTITION is not set
CONFIG_ENV_IS_IN_FLASH=y
# CONFIG_ISO_PARTITION is not set
# CONFIG_EFI_PARTITION is not set
CONFIG_ENV_IS_IN_FLASH=y
CONFIG_SMC911X=y
CONFIG_SMC911X_BASE=0x018000000
CONFIG_SMC911X_32_BIT=y
CONFIG_SMC911X=y
CONFIG_SMC911X_BASE=0x018000000
CONFIG_SMC911X_32_BIT=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_EHCI_GENERIC=y
+CONFIG_USB_OHCI_HCD=y
+CONFIG_USB_OHCI_GENERIC=y
#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_32BIT
#define CONFIG_SYS_MAX_FLASH_BANKS 1
#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_32BIT
#define CONFIG_SYS_MAX_FLASH_BANKS 1
+#ifdef CONFIG_USB_EHCI_HCD
+#define CONFIG_USB_OHCI_NEW
+#define CONFIG_SYS_USB_OHCI_MAX_ROOT_PORTS 1
+#endif
+
#define CONFIG_SYS_FLASH_EMPTY_INFO /* flinfo indicates empty blocks */
#define FLASH_MAX_SECTOR_SIZE 0x00040000
#define CONFIG_SYS_FLASH_EMPTY_INFO /* flinfo indicates empty blocks */
#define FLASH_MAX_SECTOR_SIZE 0x00040000