+#ifdef CONFIG_X86
+/*
+ * For now this code is only used on x86.
+ *
+ * init_sequence_f_r is the list of init functions which are run when
+ * U-Boot is executing from Flash with a semi-limited 'C' environment.
+ * The following limitations must be considered when implementing an
+ * '_f_r' function:
+ * - 'static' variables are read-only
+ * - Global Data (gd->xxx) is read/write
+ *
+ * The '_f_r' sequence must, as a minimum, copy U-Boot to RAM (if
+ * supported). It _should_, if possible, copy global data to RAM and
+ * initialise the CPU caches (to speed up the relocation process)
+ *
+ * NOTE: At present only x86 uses this route, but it is intended that
+ * all archs will move to this when generic relocation is implemented.
+ */
+static init_fnc_t init_sequence_f_r[] = {
+ init_cache_f_r,
+ copy_uboot_to_ram,
+ clear_bss,
+ do_elf_reloc_fixups,
+
+ NULL,
+};
+
+void board_init_f_r(void)
+{
+ if (initcall_run_list(init_sequence_f_r))
+ hang();
+
+ /*
+ * U-Boot has been copied into SDRAM, the BSS has been cleared etc.
+ * Transfer execution from Flash to RAM by calculating the address
+ * of the in-RAM copy of board_init_r() and calling it
+ */
+ (board_init_r + gd->reloc_off)(gd, gd->relocaddr);
+
+ /* NOTREACHED - board_init_r() does not return */
+ hang();
+}
+#endif /* CONFIG_X86 */
+