upstream: [media] v4l: ti-vpe: support loading of scaler coefficients
authorArchit Taneja <archit@ti.com>
Thu, 12 Dec 2013 08:35:58 +0000 (05:35 -0300)
committerChanho Park <chanho61.park@samsung.com>
Thu, 7 Aug 2014 05:26:52 +0000 (14:26 +0900)
commite1166bbde5f5562639ab0d67e06f5b1b97c6df5f
treec2e71f1d2c1051b95404650cb29c84db3d9a421e
parent264d9da4ddc042143620d57c234dc3316a67accc
upstream: [media] v4l: ti-vpe: support loading of scaler coefficients

The SC block in VPE/VIP contains a SRAM within it. This internal memory
requires to be loaded with appropriate scaler coefficients from a contiguous
block of memory through VPDMA.

The horizontal and vertical scaler each require 2 sets of scaler coefficients
for luma and chroma scaling. The horizontal polyphase scaler requires
coefficients for a 32 phase and 8 tap filter. Similarly, the vertical scaler
requires coefficients for a 5 tap filter.

The choice of the scaler coefficients depends on the scaling ratio. Add
coefficient tables for different scaling ratios in sc_coeffs.h. In the case of
horizontal downscaling, we need to consider the change in ratio caused by
decimation performed by the horizontal scaler.

In order to load the scaler coefficients via VPDMA, a configuration descriptor
is used in block mode. The payload for the descriptor is the scaler coefficients
copied to memory. Coefficients for each phase have to be placed in memory in a
particular order understood by the scaler hardware.

The choice of the scaler coefficients, and the loading of the coefficients from
our tables to a contiguous buffer is managed by the functions
sc_set_hs_coefficients and sc_set_vs_coefficients.

The sc_data handle is now added with some parameters to describe the state of
the coefficients loaded in the SC block. 'loaded_coeff_h' and 'loaded_coeff_v'
hold the address of the last dma buffer which was used by VPDMA to copy
coefficients. This information can be used by a vpe mem-to-mem context to decide
whether it should load coefficients or not. 'hs_index' and 'vs_index' provide
some optimization by preventing loading of coefficients if the scaling ratio
didn't change between 2 contexts. 'load_coeff_h' and 'load_coeff_v' tell the
vpe/vip driver whether we need to load the coefficients through VPDMA or not.

Signed-off-by: Archit Taneja <archit@ti.com>
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <m.chehab@samsung.com>
drivers/media/platform/ti-vpe/sc.c
drivers/media/platform/ti-vpe/sc.h
drivers/media/platform/ti-vpe/sc_coeff.h [new file with mode: 0644]