loop: LOOP_CONFIGURE: send uevents for partitions

loop: LOOP_CONFIGURE: send uevents for partitions

LOOP_CONFIGURE is, as far as I understand it, supposed to be a way to
combine LOOP_SET_FD and LOOP_SET_STATUS64 into a single syscall.  When
using LOOP_SET_FD+LOOP_SET_STATUS64, a single uevent would be sent for
each partition found on the loop device after the second ioctl(), but
when using LOOP_CONFIGURE, no such uevent was being sent.

In the old setup, uevents are disabled for LOOP_SET_FD, but not for
LOOP_SET_STATUS64.  This makes sense, as it prevents uevents being
sent for a partially configured device during LOOP_SET_FD - they're
only sent at the end of LOOP_SET_STATUS64.  But for LOOP_CONFIGURE,
uevents were disabled for the entire operation, so that final
notification was never issued.  To fix this, reduce the critical
section to exclude the loop_reread_partitions() call, which causes
the uevents to be issued, to after uevents are re-enabled, matching
the behaviour of the LOOP_SET_FD+LOOP_SET_STATUS64 combination.

I noticed this because Busybox's losetup program recently changed from
using LOOP_SET_FD+LOOP_SET_STATUS64 to LOOP_CONFIGURE, and this broke
my setup, for which I want a notification from the kernel any time a
new partition becomes available.

Signed-off-by: Alyssa Ross <hi@alyssa.is>
[hch: reduced the critical section]
Signed-off-by: Christoph Hellwig <hch@lst.de>
Fixes: 3448914e8cc5 ("loop: Add LOOP_CONFIGURE ioctl")
Link: https://lore.kernel.org/r/20230320125430.55367-1-hch@lst.de
Signed-off-by: Jens Axboe <axboe@kernel.dk>