mmc: rockchip_sdhci: Add support for RK3588

mmc: rockchip_sdhci: Add support for RK3588

Add support for RK3588 to the rockchip sdhci driver.

Use driver data to handle differences between RK3568 and RK3588:

- Set "Receive original clock source is auto gating" for RK3588.
- Set "Receive clock source is no-inverted" only on RK3568 and "Transmit
  clock source is invertion of original clock input" for RK3588.
- Use different txclk_tapnum for HS400 modes on RK3588.
- Configure the CMDOUT reg for HS400 modes for RK3588.

This is based on the mainline linux and vendor kernel driver and have
successfully been tested with rock5b-rk3588_defconfig and

  CONFIG_MMC_HS200_SUPPORT=y
  CONFIG_MMC_HS400_SUPPORT=y
  CONFIG_MMC_HS400_ES_SUPPORT=y
  CONFIG_MMC_SPEED_MODE_SET=y

using the following command to switch mode and then read 512 MiB of data
from eMMC into memory,

  => mmc dev 0 0 <mode> && mmc info && mmc read 10000000 2000 10000

for each of the modes below.

  0 = MMC legacy
  1 = MMC High Speed (26MHz)
  3 = MMC High Speed (52MHz)
  4 = MMC DDR52 (52MHz)
  10 = HS200 (200MHz)
  11 = HS400 (200MHz)
  12 = HS400ES (200MHz)

Signed-off-by: Yifeng Zhao <yifeng.zhao@rock-chips.com>
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>