netfilter: set default timeout to 3 secs for sctp shutdown send and recv state

netfilter: set default timeout to 3 secs for sctp shutdown send and recv state

In SCTP protocol, it is using the same timer (T2 timer) for SHUTDOWN and
SHUTDOWN_ACK retransmission. However in sctp conntrack the default timeout
value for SCTP_CONNTRACK_SHUTDOWN_ACK_SENT state is 3 secs while it's 300
msecs for SCTP_CONNTRACK_SHUTDOWN_SEND/RECV state.

As Paolo Valerio noticed, this might cause unwanted expiration of the ct
entry. In my test, with 1s tc netem delay set on the NAT path, after the
SHUTDOWN is sent, the sctp ct entry enters SCTP_CONNTRACK_SHUTDOWN_SEND
state. However, due to 300ms (too short) delay, when the SHUTDOWN_ACK is
sent back from the peer, the sctp ct entry has expired and been deleted,
and then the SHUTDOWN_ACK has to be dropped.

Also, it is confusing these two sysctl options always show 0 due to all
timeout values using sec as unit:

  net.netfilter.nf_conntrack_sctp_timeout_shutdown_recd = 0
  net.netfilter.nf_conntrack_sctp_timeout_shutdown_sent = 0

This patch fixes it by also using 3 secs for sctp shutdown send and recv
state in sctp conntrack, which is also RTO.initial value in SCTP protocol.

Note that the very short time value for SCTP_CONNTRACK_SHUTDOWN_SEND/RECV
was probably used for a rare scenario where SHUTDOWN is sent on 1st path
but SHUTDOWN_ACK is replied on 2nd path, then a new connection started
immediately on 1st path. So this patch also moves from SHUTDOWN_SEND/RECV
to CLOSE when receiving INIT in the ORIGINAL direction.

Fixes: 9fb9cbb1082d ("[NETFILTER]: Add nf_conntrack subsystem.")
Reported-by: Paolo Valerio <pvalerio@redhat.com>
Signed-off-by: Xin Long <lucien.xin@gmail.com>
Reviewed-by: Simon Horman <horms@kernel.org>
Signed-off-by: Florian Westphal <fw@strlen.de>