net/mlx5e: Add support for hw decapsulation of MPLS over UDP
MPLS over UDP is supported in hardware by using a packet reformat object
with reformat type equal L3_TUNNEL_TO_L2 which both decapsulates the
outer L3, L4 and MPLS headers, and allows for setting the L2 headers of
the resulting decapsulated packet. For the hardware to operate
correctly, the configuration of the firmware must have
FLEX_PARSER_PROFILE_ENABLE = 1.
Example tc rule:
tc filter add dev bareudp0 protocol all prio 1 root flower enc_dst_port \
6635 enc_src_ip 8.8.8.23 action mpls pop protocol ip pipe \
action pedit ex munge eth dst set 00:11:22:33:44:21 pipe action \
mirred egress redirect dev enp59s0f0_0
We use pedit to set the correct destination MAC.
For MPLS over UDP decapsulation to take place, the driver logic requires
the following:
1. flower filter added on bareudp device.
2. action mpls pop
3. zero or more pedit munge actions
4. one redirect action
Current implementation supports only IPv4 and no VLAN.
tc filter show output looks like this:
filter protocol all pref 1 flower chain 0
filter protocol all pref 1 flower chain 0 handle 0x1
enc_src_ip 8.8.8.24
enc_dst_port 6635
in_hw in_hw_count 1
action order 1: mpls pop protocol ip pipe
index 2 ref 1 bind 1
action order 2: pedit action pipe keys 2
index 1 ref 1 bind 1
key #0 at eth+0: val
00112233 mask
00000000
key #1 at eth+4: val
44210000 mask
0000ffff
action order 3: mirred (Egress Redirect to device enp59s0f0_0) stolen
index 2 ref 1 bind 1
Signed-off-by: Eli Cohen <eli@mellanox.com>
Reviewed-by: Roi Dayan <roid@mellanox.com>
Reviewed-by: Eli Britstein <elibr@mellanox.com>
Reviewed-by: Vlad Buslov <vladbu@mellanox.com>
Reviewed-by: Paul Blakey <paulb@mellanox.com>
Signed-off-by: Saeed Mahameed <saeedm@mellanox.com>