X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2Fp1_twr.h;h=1e49ee6e22db127f8167376f2b3967f20c5809e5;hb=e16e137c377c8b96d8d91263d0b6d8470169f841;hp=9864c15d837cf2515c18c64db02923f2b0664bd9;hpb=fc9b0b80435cda721fbdbe507c9e4f388b0ea62b;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/p1_twr.h b/include/configs/p1_twr.h
index 9864c15..1e49ee6 100644
--- a/include/configs/p1_twr.h
+++ b/include/configs/p1_twr.h
@@ -10,7 +10,6 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-#define	CONFIG_SYS_GENERIC_BOARD
 #define	CONFIG_DISPLAY_BOARDINFO
 #if defined(CONFIG_TWR_P1025)
 #define CONFIG_BOARDNAME "TWR-P1025"
@@ -216,7 +215,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  */
 #define CONFIG_CONS_INDEX		1
 #undef CONFIG_SERIAL_SOFTWARE_FIFO
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE	1
 #define CONFIG_SYS_NS16550_CLK		get_bus_freq(0)
@@ -233,17 +231,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
 #endif
 
-/*
- * Pass open firmware flat tree
- */
-#define CONFIG_OF_LIBFDT
-#define CONFIG_OF_BOARD_SETUP
-#define CONFIG_OF_STDOUT_VIA_ALIAS
-
-/* new uImage format support */
-#define CONFIG_FIT
-#define CONFIG_FIT_VERBOSE	/* enable fit_format_{error,warning}() */
-
 /* I2C */
 #define CONFIG_SYS_I2C
 #define CONFIG_SYS_I2C_FSL			/* Use FSL common I2C driver */
@@ -263,7 +250,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 /* enable read and write access to EEPROM */
 #define CONFIG_CMD_EEPROM
-#define CONFIG_SYS_I2C_MULTI_EEPROMS
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -272,7 +258,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  * eSPI - Enhanced SPI
  */
 #define CONFIG_HARD_SPI
-#define CONFIG_FSL_ESPI
 
 #if defined(CONFIG_PCI)
 /*
@@ -302,11 +287,8 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_PCIE1_IO_PHYS	0xffc00000
 #define CONFIG_SYS_PCIE1_IO_SIZE	0x00010000	/* 64k */
 
-#define CONFIG_NET_MULTI
 #define CONFIG_PCI_PNP	/* do pci plug-and-play */
-#define CONFIG_E1000	/* Defind e1000 pci Ethernet card*/
 #define CONFIG_CMD_PCI
-#define CONFIG_CMD_NET
 
 #define CONFIG_PCI_SCAN_SHOW	/* show pci devices on startup */
 #define CONFIG_DOS_PARTITION
@@ -314,10 +296,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 #if defined(CONFIG_TSEC_ENET)
 
-#ifndef CONFIG_NET_MULTI
-#define CONFIG_NET_MULTI
-#endif
-
 #define CONFIG_MII		/* MII PHY management */
 #define CONFIG_TSEC1
 #define CONFIG_TSEC1_NAME	"eTSEC1"
@@ -428,14 +406,10 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_MII
-#define CONFIG_CMD_ELF
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_REGINFO
 
 /*