X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2Fluan.h;h=41999d32f97aaa2142080c1bbf7886e97349d3d2;hb=3c1de1a6d36be9eee284a6c596a86e94f19cc5b2;hp=cba7295fe97219dbee6ef8de3e87fea685f196a4;hpb=a449c500b1abf8d63e774145f85c35efaecef3e5;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/luan.h b/include/configs/luan.h
index cba7295..41999d3 100644
--- a/include/configs/luan.h
+++ b/include/configs/luan.h
@@ -68,7 +68,6 @@
 #define CFG_FLASH_BASE		CFG_SMALL_FLASH
 #endif
 
-#undef CFG_DRAM_TEST
 #if CFG_SRAM_BASE
 #define CFG_KBYTES_SDRAM	1024*2
 #else
@@ -152,7 +151,7 @@
 #define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10
 
 #define CONFIG_PREBOOT	"echo;"	\
-	"echo Type \"run flash_nfs\" to mount root filesystem over NFS;" \
+	"echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
 	"echo"
 
 #undef	CONFIG_BOOTARGS
@@ -182,7 +181,7 @@
 	"update=protect off fffc0000 ffffffff;era fffc0000 ffffffff;"	\
 		"cp.b 100000 fffc0000 40000;"			        \
 		"setenv filesize;saveenv\0"				\
-	"upd=run load;run update\0"					\
+	"upd=run load update\0"						\
 	""
 #define CONFIG_BOOTCOMMAND	"run flash_self"
 
@@ -195,6 +194,7 @@
 #define CONFIG_LOADS_ECHO	1	/* echo on for serial download	*/
 #define CFG_LOADS_BAUD_CHANGE	1	/* allow baudrate change	*/
 
+#define CONFIG_HAS_ETH0
 #define CONFIG_MII		1	/* MII PHY management		*/
 #define CONFIG_PHY_ADDR		1
 #define CONFIG_CIS8201_PHY	1	/* Enable 'special' RGMII mode for Cicada phy */
@@ -306,4 +306,8 @@
 #define CONFIG_KGDB_SER_INDEX	2	/* which serial port to use */
 #endif
 
+/* pass open firmware flat tree */
+#define CONFIG_OF_LIBFDT	1
+#define CONFIG_OF_BOARD_SETUP	1
+
 #endif	/* __CONFIG_H */