X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2Fls1046aqds.h;h=9231cca9e95d6200f9f9dd3b6ccc38ee5e8b993e;hb=e090579d0a2d1aa38eab94b98877de9bcdd4f31d;hp=2e5c2f181fff92de4db9040998d5640ff7dfd6a8;hpb=126fe70d7746d7e60a6331391cab6713368b78dc;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/ls1046aqds.h b/include/configs/ls1046aqds.h
index 2e5c2f1..9231cca 100644
--- a/include/configs/ls1046aqds.h
+++ b/include/configs/ls1046aqds.h
@@ -9,13 +9,10 @@
 
 #include "ls1046a_common.h"
 
-#define CONFIG_DISPLAY_CPUINFO
-#define CONFIG_DISPLAY_BOARDINFO
-
 #if defined(CONFIG_NAND_BOOT) || defined(CONFIG_SD_BOOT)
 #define CONFIG_SYS_TEXT_BASE		0x82000000
 #elif defined(CONFIG_QSPI_BOOT)
-#define CONFIG_SYS_TEXT_BASE		0x40010000
+#define CONFIG_SYS_TEXT_BASE		0x40100000
 #else
 #define CONFIG_SYS_TEXT_BASE		0x60100000
 #endif
@@ -41,7 +38,9 @@ unsigned long get_board_ddr_clk(void);
 #define SPD_EEPROM_ADDRESS		0x51
 #define CONFIG_SYS_SPD_BUS_NUM		0
 
+#ifndef CONFIG_SPL
 #define CONFIG_FSL_DDR_INTERACTIVE	/* Interactive debugging */
+#endif
 
 #define CONFIG_DDR_ECC
 #ifdef CONFIG_DDR_ECC
@@ -49,8 +48,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_MEM_INIT_VALUE           0xdeadbeef
 #endif
 
-#define CONFIG_SYS_HAS_SERDES
-
 /* DSPI */
 #ifdef CONFIG_FSL_DSPI
 #define CONFIG_SPI_FLASH_STMICRO	/* cs0 */
@@ -73,7 +70,6 @@ unsigned long get_board_ddr_clk(void);
 
 #ifdef CONFIG_SYS_DPAA_FMAN
 #define CONFIG_FMAN_ENET
-#define CONFIG_PHYLIB
 #define CONFIG_PHY_VITESSE
 #define CONFIG_PHY_REALTEK
 #define CONFIG_PHYLIB_10G
@@ -123,7 +119,7 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_FLASH_BASE_PHYS		CONFIG_SYS_FLASH_BASE
 #define CONFIG_SYS_FLASH_BASE_PHYS_EARLY	0x00000000
 
-#ifndef CONFIG_SYS_NO_FLASH
+#ifdef CONFIG_MTD_NOR_FLASH
 #define CONFIG_FLASH_CFI_DRIVER
 #define CONFIG_SYS_FLASH_CFI
 #define CONFIG_SYS_FLASH_USE_BUFFER_WRITE
@@ -132,13 +128,25 @@ unsigned long get_board_ddr_clk(void);
 #endif
 #endif
 
+/* LPUART */
+#ifdef CONFIG_LPUART
+#define CONFIG_LPUART_32B_REG
+#define CFG_UART_MUX_MASK	0x6
+#define CFG_UART_MUX_SHIFT	1
+#define CFG_LPUART_EN		0x2
+#endif
+
+/* USB */
+#define CONFIG_HAS_FSL_XHCI_USB
+#ifdef CONFIG_HAS_FSL_XHCI_USB
+#define CONFIG_USB_XHCI_FSL
+#define CONFIG_USB_MAX_CONTROLLER_COUNT         3
+#endif
+
 /* SATA */
 #define CONFIG_LIBATA
 #define CONFIG_SCSI_AHCI
 #define CONFIG_SCSI_AHCI_PLAT
-#define CONFIG_SCSI
-#define CONFIG_DOS_PARTITION
-#define CONFIG_BOARD_LATE_INIT
 
 /* EEPROM */
 #define CONFIG_ID_EEPROM
@@ -240,7 +248,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_NAND_BASE_LIST	{ CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE	1
 #define CONFIG_MTD_NAND_VERIFY_WRITE
-#define CONFIG_CMD_NAND
 
 #define CONFIG_SYS_NAND_BLOCK_SIZE	(256 * 1024)
 #endif
@@ -254,7 +261,6 @@ unsigned long get_board_ddr_clk(void);
 #if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
 #define CONFIG_QIXIS_I2C_ACCESS
 #define CONFIG_SYS_I2C_EARLY_INIT
-#define CONFIG_SYS_NO_FLASH
 #endif
 
 /*
@@ -411,21 +417,12 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_MISC_INIT_R
 #define CONFIG_SYS_LONGHELP		/* undef to save memory */
 #define CONFIG_AUTO_COMPLETE
-#define CONFIG_SYS_PBSIZE		\
-		(CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
-#define CONFIG_SYS_BARGSIZE		CONFIG_SYS_CBSIZE
 
 #define CONFIG_SYS_MEMTEST_START	0x80000000
 #define CONFIG_SYS_MEMTEST_END		0x9fffffff
 
 #define CONFIG_SYS_HZ			1000
 
-/*
- * Stack sizes
- * The stack sizes are set up in start.S using the settings below
- */
-#define CONFIG_STACKSIZE		(30 * 1024)
-
 #define CONFIG_SYS_INIT_SP_OFFSET \
 	(CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 
@@ -437,28 +434,25 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_ENV_OVERWRITE
 
 #ifdef CONFIG_NAND_BOOT
-#define CONFIG_ENV_IS_IN_NAND
 #define CONFIG_ENV_SIZE			0x2000
-#define CONFIG_ENV_OFFSET		(5 * CONFIG_SYS_NAND_BLOCK_SIZE)
+#define CONFIG_ENV_OFFSET		(24 * CONFIG_SYS_NAND_BLOCK_SIZE)
 #elif defined(CONFIG_SD_BOOT)
-#define CONFIG_ENV_OFFSET		(1024 * 1024)
-#define CONFIG_ENV_IS_IN_MMC
+#define CONFIG_ENV_OFFSET		(3 * 1024 * 1024)
 #define CONFIG_SYS_MMC_ENV_DEV		0
 #define CONFIG_ENV_SIZE			0x2000
 #elif defined(CONFIG_QSPI_BOOT)
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SIZE			0x2000          /* 8KB */
-#define CONFIG_ENV_OFFSET		0x100000        /* 1MB */
+#define CONFIG_ENV_OFFSET		0x300000        /* 3MB */
 #define CONFIG_ENV_SECT_SIZE		0x10000
 #else
-#define CONFIG_ENV_IS_IN_FLASH
-#define CONFIG_ENV_ADDR			(CONFIG_SYS_FLASH_BASE + 0x200000)
+#define CONFIG_ENV_ADDR			(CONFIG_SYS_FLASH_BASE + 0x300000)
 #define CONFIG_ENV_SECT_SIZE		0x20000
 #define CONFIG_ENV_SIZE			0x20000
 #endif
 
 #define CONFIG_CMDLINE_TAG
 
+#undef CONFIG_BOOTCOMMAND
 #if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
 #define CONFIG_BOOTCOMMAND		"sf probe && sf read $kernel_load "    \
 					"e0000 f00000 && bootm $kernel_load"
@@ -471,12 +465,14 @@ unsigned long get_board_ddr_clk(void);
 #define MTDPARTS_DEFAULT "mtdparts=1550000.quadspi:2m(uboot)," \
 			"14m(free)"
 #else
-#define MTDPARTS_DEFAULT "mtdparts=60000000.nor:1m(nor_bank0_rcw)," \
-			"1m(nor_bank0_uboot),1m(nor_bank0_uboot_env)," \
-			"1m(nor_bank0_fman_uconde),40m(nor_bank0_fit)," \
-			"1m(nor_bank4_rcw),1m(nor_bank4_uboot)," \
-			"1m(nor_bank4_uboot_env),1m(nor_bank4_fman_ucode)," \
-			"40m(nor_bank4_fit);7e800000.flash:" \
+#define MTDPARTS_DEFAULT "mtdparts=60000000.nor:" \
+			"2m@0x100000(nor_bank0_uboot),"\
+			"40m@0x1100000(nor_bank0_fit)," \
+			"7m(nor_bank0_user)," \
+			"2m@0x4100000(nor_bank4_uboot)," \
+			"40m@0x5100000(nor_bank4_fit),"\
+			"-(nor_bank4_user);" \
+			"7e800000.flash:" \
 			"4m(nand_uboot),36m(nand_kernel)," \
 			"472m(nand_free);spi0.0:2m(uboot)," \
 			"14m(free)"