X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2Fda850evm.h;h=319f6aadf5be8473c13384eae1c346305fce599c;hb=0223462b373b975d970fa86e5e1a7eadd1d41820;hp=dcae282e289f16b5a604d9cbe084632e0300fd8f;hpb=6f6b7cfa89e5aa3b643196a4ccc8b1ba5d6fa7a4;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/da850evm.h b/include/configs/da850evm.h
index dcae282..319f6aa 100644
--- a/include/configs/da850evm.h
+++ b/include/configs/da850evm.h
@@ -1,11 +1,10 @@
+/* SPDX-License-Identifier: GPL-2.0+ */
 /*
  * Copyright (C) 2010 Texas Instruments Incorporated - http://www.ti.com/
  *
  * Based on davinci_dvevm.h. Original Copyrights follow:
  *
  * Copyright (C) 2007 Sergey Kubushyn <ksi@koi8.net>
- *
- * SPDX-License-Identifier:	GPL-2.0+
  */
 
 #ifndef __CONFIG_H
@@ -14,7 +13,6 @@
 /*
  * Board
  */
-#define CONFIG_DRIVER_TI_EMAC
 /* check if direct NOR boot config is used */
 #ifndef CONFIG_DIRECT_NOR_BOOT
 #define CONFIG_USE_SPIFLASH
@@ -38,10 +36,10 @@
 #define CONFIG_SYS_OSCIN_FREQ		24000000
 #define CONFIG_SYS_TIMERBASE		DAVINCI_TIMER0_BASE
 #define CONFIG_SYS_HZ_CLOCK		clk_get(DAVINCI_AUXCLK_CLKID)
+#define CONFIG_SKIP_LOWLEVEL_INIT
 
 #ifdef CONFIG_DIRECT_NOR_BOOT
 #define CONFIG_ARCH_CPU_INIT
-#define CONFIG_DA8XX_GPIO
 #define CONFIG_SYS_DV_NOR_BOOT_CFG	(0x11)
 #endif
 
@@ -59,8 +57,6 @@
 /* memtest will be run on 16MB */
 #define CONFIG_SYS_MEMTEST_END 	(PHYS_SDRAM_1 + 0x2000000 + 16*1024*1024)
 
-#define CONFIG_NR_DRAM_BANKS	1 /* we have 1 bank of DRAM */
-
 #define CONFIG_SYS_DA850_SYSCFG_SUSPSRC (	\
 	DAVINCI_SYSCFG_SUSPSRC_TIMER0 |		\
 	DAVINCI_SYSCFG_SUSPSRC_SPI1 |		\
@@ -120,14 +116,13 @@
  * Serial Driver info
  */
 
-#if defined(CONFIG_SPL_BUILD) || defined(CONFIG_DIRECT_NOR_BOOT)
+#if !CONFIG_IS_ENABLED(DM_SERIAL)
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE	-4	/* NS16550 register size */
 #define CONFIG_SYS_NS16550_COM1	DAVINCI_UART2_BASE /* Base address of UART2 */
 #endif
 #define CONFIG_SYS_NS16550_CLK	clk_get(DAVINCI_UART2_CLKID)
 
-#define CONFIG_SPI
 #define CONFIG_SYS_SPI_CLK		clk_get(DAVINCI_SPI1_CLKID)
 #ifdef CONFIG_SPL_BUILD
 #define CONFIG_SYS_SPI_BASE		DAVINCI_SPI1_BASE
@@ -136,7 +131,6 @@
 #endif
 
 #ifdef CONFIG_USE_SPIFLASH
-#define CONFIG_SPL_SPI_LOAD
 #define CONFIG_SYS_SPI_U_BOOT_OFFS	0x8000
 #define CONFIG_SYS_SPI_U_BOOT_SIZE	0x40000
 #endif
@@ -145,17 +139,18 @@
  * I2C Configuration
  */
 #ifndef CONFIG_SPL_BUILD
-#define CONFIG_SYS_I2C_DAVINCI
 #define CONFIG_SYS_I2C_EXPANDER_ADDR   0x20
 #endif
 
 /*
  * Flash & Environment
  */
-#ifdef CONFIG_USE_NAND
-#define CONFIG_NAND_DAVINCI
+#ifdef CONFIG_NAND
+#ifdef CONFIG_ENV_IS_IN_NAND
 #define CONFIG_ENV_OFFSET		0x0 /* Block 0--not used by bootcode */
 #define CONFIG_ENV_SIZE			(128 << 10)
+#define CONFIG_ENV_SECT_SIZE	(128 << 10)
+#endif
 #define	CONFIG_SYS_NAND_USE_FLASH_BBT
 #define CONFIG_SYS_NAND_4BIT_HW_ECC_OOBFIRST
 #define	CONFIG_SYS_NAND_PAGE_2K
@@ -169,8 +164,7 @@
 #define CONFIG_SYS_NAND_5_ADDR_CYCLE
 #define CONFIG_SYS_NAND_PAGE_SIZE	(2 << 10)
 #define CONFIG_SYS_NAND_BLOCK_SIZE	(128 << 10)
-#define CONFIG_SYS_NAND_U_BOOT_OFFS	0x28000
-#define CONFIG_SYS_NAND_U_BOOT_SIZE	0x60000
+#define CONFIG_SYS_NAND_U_BOOT_SIZE	0x40000
 #define CONFIG_SYS_NAND_U_BOOT_DST	0xc1080000
 #define CONFIG_SYS_NAND_U_BOOT_START	CONFIG_SYS_NAND_U_BOOT_DST
 #define CONFIG_SYS_NAND_U_BOOT_RELOC_SP	(CONFIG_SYS_NAND_U_BOOT_DST - \
@@ -198,7 +192,6 @@
  * Network & Ethernet Configuration
  */
 #ifdef CONFIG_DRIVER_TI_EMAC
-#define CONFIG_MII
 #define CONFIG_BOOTP_DNS2
 #define CONFIG_BOOTP_SEND_HOSTNAME
 #define CONFIG_NET_RETRY_COUNT	10
@@ -220,20 +213,19 @@
 #endif
 
 #ifdef CONFIG_USE_SPIFLASH
+#ifdef CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SIZE			(64 << 10)
 #define CONFIG_ENV_OFFSET		(512 << 10)
-#define CONFIG_ENV_SECT_SIZE		(64 << 10)
+#define CONFIG_ENV_SECT_SIZE	(64 << 10)
+#endif
 #ifdef CONFIG_SPL_BUILD
 #undef CONFIG_SPI_FLASH_MTD
 #endif
-#define CONFIG_MTD_DEVICE		/* needed for mtdparts commands */
-#define CONFIG_MTD_PARTITIONS		/* required for UBI partition support */
 #endif
 
 /*
  * U-Boot general configuration
  */
-#define CONFIG_MISC_INIT_R
 #define CONFIG_BOOTFILE		"uImage" /* Boot file name */
 #define CONFIG_SYS_CBSIZE	1024 /* Console I/O Buffer Size	*/
 #define CONFIG_SYS_BARGSIZE	CONFIG_SYS_CBSIZE /* Boot Args Buffer Size */
@@ -276,12 +268,7 @@
 #define CONFIG_CLOCKS
 #endif
 
-#ifdef CONFIG_USE_NAND
-#define CONFIG_MTD_DEVICE
-#define CONFIG_MTD_PARTITIONS
-#endif
-
-#if !defined(CONFIG_USE_NAND) && \
+#if !defined(CONFIG_NAND) && \
 	!defined(CONFIG_USE_NOR) && \
 	!defined(CONFIG_USE_SPIFLASH)
 #define CONFIG_ENV_SIZE		(16 << 10)
@@ -292,7 +279,6 @@
 #define CONFIG_SYS_SPL_MALLOC_START	(CONFIG_SYS_TEXT_BASE - \
 						CONFIG_SYS_MALLOC_LEN)
 #define CONFIG_SYS_SPL_MALLOC_SIZE	CONFIG_SYS_MALLOC_LEN
-#define CONFIG_SPL_SPI_LOAD
 #define CONFIG_SPL_STACK	0x8001ff00
 #define CONFIG_SPL_TEXT_BASE	0x80000000
 #define CONFIG_SPL_MAX_FOOTPRINT	32768
@@ -300,9 +286,6 @@
 #endif
 
 /* Load U-Boot Image From MMC */
-#ifdef CONFIG_SPL_MMC_LOAD
-#undef CONFIG_SPL_SPI_LOAD
-#endif
 
 /* additions for new relocation code, must added to all boards */
 #define CONFIG_SYS_SDRAM_BASE		0xc0000000