X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FT208xRDB.h;h=fc0007d1ac83ce3b8ad4dd485b0300aab618382e;hb=4862830b696a6d0750e19d32a82553cdb41a85f8;hp=934e6e47411a04b6ea025d1ab0c53217f6e30632;hpb=e8f80a5a58c9b506453cc0780687e8ed457d30a6;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/T208xRDB.h b/include/configs/T208xRDB.h
index 934e6e4..fc0007d 100644
--- a/include/configs/T208xRDB.h
+++ b/include/configs/T208xRDB.h
@@ -15,7 +15,6 @@
 
 /* High Level Configuration Options */
 #define CONFIG_SYS_BOOK3E_HV	/* Category E.HV supported */
-#define CONFIG_MP		/* support multiple processors */
 #define CONFIG_ENABLE_36BIT_PHYS
 
 #ifdef CONFIG_PHYS_64BIT
@@ -31,8 +30,6 @@
 #define CONFIG_SYS_FSL_PBL_PBI board/freescale/t208xrdb/t2080_pbi.cfg
 
 #define CONFIG_SPL_FLUSH_IMAGE
-#define CONFIG_SPL_TARGET		"u-boot-with-spl.bin"
-#define CONFIG_SPL_TEXT_BASE		0xFFFD8000
 #define CONFIG_SPL_PAD_TO		0x40000
 #define CONFIG_SPL_MAX_SIZE		0x28000
 #define RESET_VECTOR_OFFSET		0x27FFC
@@ -111,28 +108,15 @@
 #define CONFIG_SYS_MEMTEST_START	0x00200000 /* memtest works on */
 #define CONFIG_SYS_MEMTEST_END		0x00400000
 
-#ifdef CONFIG_MTD_NOR_FLASH
-#define CONFIG_FLASH_CFI_DRIVER
-#define CONFIG_SYS_FLASH_CFI
-#define CONFIG_SYS_FLASH_USE_BUFFER_WRITE
-#endif
-
 #if defined(CONFIG_SPIFLASH)
-#define CONFIG_SYS_EXTRA_ENV_RELOC
-#define CONFIG_ENV_SPI_BUS	0
-#define CONFIG_ENV_SPI_CS	0
-#define CONFIG_ENV_SPI_MAX_HZ	10000000
-#define CONFIG_ENV_SPI_MODE	0
 #define CONFIG_ENV_SIZE		0x2000	   /* 8KB */
 #define CONFIG_ENV_OFFSET	0x100000   /* 1MB */
 #define CONFIG_ENV_SECT_SIZE	0x10000
 #elif defined(CONFIG_SDCARD)
-#define CONFIG_SYS_EXTRA_ENV_RELOC
 #define CONFIG_SYS_MMC_ENV_DEV	0
 #define CONFIG_ENV_SIZE		0x2000
 #define CONFIG_ENV_OFFSET	(512 * 0x800)
 #elif defined(CONFIG_NAND)
-#define CONFIG_SYS_EXTRA_ENV_RELOC
 #define CONFIG_ENV_SIZE		0x2000
 #define CONFIG_ENV_OFFSET	(2 * CONFIG_SYS_NAND_BLOCK_SIZE)
 #elif defined(CONFIG_SRIO_PCIE_BOOT_SLAVE)
@@ -166,7 +150,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SPL_RELOC_MALLOC_ADDR	(CONFIG_SPL_GD_ADDR + 12 * 1024)
 #define CONFIG_SPL_RELOC_MALLOC_SIZE	(50 << 10)
 #define CONFIG_SPL_RELOC_STACK		(CONFIG_SPL_GD_ADDR + 64 * 1024)
-#define CONFIG_SPL_RELOC_STACK_SIZE	(22 << 10)
 
 #define CONFIG_SYS_DCSRBAR	0xf0000000
 #define CONFIG_SYS_DCSRBAR_PHYS	0xf00000000ull
@@ -187,7 +170,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
 #define CONFIG_CHIP_SELECTS_PER_CTRL	(4 * CONFIG_DIMM_SLOTS_PER_CTLR)
 #define CONFIG_DDR_SPD
-#undef CONFIG_FSL_DDR_INTERACTIVE
 #define CONFIG_SYS_SPD_BUS_NUM	0
 #define CONFIG_SYS_SDRAM_SIZE	2048	/* for fixed parameter use */
 #define SPD_EEPROM_ADDRESS1	0x51
@@ -341,7 +323,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_MONITOR_BASE  CONFIG_SYS_TEXT_BASE /* start of monitor */
 #endif
 
-#define CONFIG_MISC_INIT_R
 #define CONFIG_HWCONFIG
 
 /* define to use L1 as initial stack */
@@ -449,11 +430,6 @@ unsigned long get_board_ddr_clk(void);
 /*
  * eSPI - Enhanced SPI
  */
-#ifdef CONFIG_SPI_FLASH
-#define CONFIG_SPI_FLASH_BAR
-#define CONFIG_SF_DEFAULT_SPEED	 10000000
-#define CONFIG_SF_DEFAULT_MODE	  0
-#endif
 
 /*
  * General PCI
@@ -595,8 +571,6 @@ unsigned long get_board_ddr_clk(void);
 
 #ifdef CONFIG_SYS_DPAA_FMAN
 #define CONFIG_FMAN_ENET
-#define CONFIG_PHYLIB_10G
-#define CONFIG_PHY_AQUANTIA
 #define CONFIG_PHY_CORTINA
 #define CONFIG_PHY_REALTEK
 #define CONFIG_CORTINA_FW_LENGTH	0x40000
@@ -609,7 +583,6 @@ unsigned long get_board_ddr_clk(void);
 #endif
 
 #ifdef CONFIG_FMAN_ENET
-#define CONFIG_MII		/* MII PHY management */
 #define CONFIG_ETHPRIME		"FM1@DTSEC3"
 #endif
 
@@ -648,11 +621,6 @@ unsigned long get_board_ddr_clk(void);
 /*
  * Dynamic MTD Partition support with mtdparts
  */
-#ifdef CONFIG_MTD_NOR_FLASH
-#define CONFIG_MTD_DEVICE
-#define CONFIG_MTD_PARTITIONS
-#define CONFIG_FLASH_CFI_MTD
-#endif
 
 /*
  * Environment