X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FP1010RDB.h;h=2dee5ac01c4ded1ff85828ba233614fce10fa257;hb=1989374b21089c63019fc9648408c8d609023ffe;hp=cd9cd9ac56469a88d15e97043c0748febff1fb95;hpb=d26e34c4c4b6473fdbd412a3b2dc33a94b08e8ff;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/P1010RDB.h b/include/configs/P1010RDB.h
index cd9cd9a..2dee5ac 100644
--- a/include/configs/P1010RDB.h
+++ b/include/configs/P1010RDB.h
@@ -130,8 +130,6 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_FSL_IFC			/* Enable IFC Support */
-#define CONFIG_FSL_CAAM			/* Enable SEC/CAAM */
 #define CONFIG_SYS_HAS_SERDES		/* common SERDES init code */
 
 #if defined(CONFIG_PCI)
@@ -193,7 +191,6 @@
 #endif
 
 #define CONFIG_PCI_SCAN_SHOW		/* show pci devices on startup */
-#define CONFIG_DOS_PARTITION
 #endif
 
 #define CONFIG_TSEC_ENET
@@ -305,9 +302,6 @@ extern unsigned long get_sdram_size(void);
  * IFC Definitions
  */
 /* NOR Flash on IFC */
-#ifdef CONFIG_SPL_BUILD
-#define CONFIG_SYS_NO_FLASH
-#endif
 
 #define CONFIG_SYS_FLASH_BASE		0xee000000
 #define CONFIG_SYS_MAX_FLASH_SECT	256	/* 32M */
@@ -360,7 +354,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_MTD_DEVICE
 #define CONFIG_MTD_PARTITION
-#define CONFIG_CMD_MTDPARTS
 #define MTDIDS_DEFAULT			"nand0=ff800000.flash"
 #define MTDPARTS_DEFAULT		\
 	"mtdparts=ff800000.flash:2m(uboot-env),1m(dtb),5m(kernel),56m(fs),-(usr)"
@@ -395,7 +388,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_SYS_NAND_BASE_LIST	{ CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE	1
-#define CONFIG_CMD_NAND
 
 #if defined(CONFIG_TARGET_P1010RDB_PA)
 /* NAND Flash Timing Params */
@@ -504,7 +496,6 @@ extern unsigned long get_sdram_size(void);
 #endif
 #endif
 
-#define CONFIG_BOARD_EARLY_INIT_F	/* Call board_pre_init */
 #define CONFIG_BOARD_EARLY_INIT_R
 
 #define CONFIG_SYS_INIT_RAM_LOCK
@@ -596,7 +587,6 @@ extern unsigned long get_sdram_size(void);
 #define MAX_NUM_PORTS			9 /* for 128Bytes EEPROM */
 #endif
 /* enable read and write access to EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -639,8 +629,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_ETHPRIME		"eTSEC1"
 
-#define CONFIG_PHY_GIGE		/* Include GbE speed/duplex detection */
-
 /* TBI PHY configuration for SGMII mode */
 #define CONFIG_TSEC_TBICR_SETTINGS ( \
 		TBICR_PHY_RESET \
@@ -665,23 +653,18 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_SATA2		CONFIG_SYS_MPC85xx_SATA2_ADDR
 #define CONFIG_SYS_SATA2_FLAGS		FLAGS_DMA
 
-#define CONFIG_CMD_SATA
 #define CONFIG_LBA48
 #endif /* #ifdef CONFIG_FSL_SATA  */
 
 #ifdef CONFIG_MMC
-#define CONFIG_DOS_PARTITION
 #define CONFIG_FSL_ESDHC
-#define CONFIG_GENERIC_MMC
 #define CONFIG_SYS_FSL_ESDHC_ADDR	CONFIG_SYS_MPC85xx_ESDHC_ADDR
 #endif
 
 #define CONFIG_HAS_FSL_DR_USB
 
 #if defined(CONFIG_HAS_FSL_DR_USB)
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #endif
@@ -691,12 +674,10 @@ extern unsigned long get_sdram_size(void);
  * Environment
  */
 #if defined(CONFIG_SDCARD)
-#define CONFIG_ENV_IS_IN_MMC
 #define CONFIG_FSL_FIXED_MMC_LOCATION
 #define CONFIG_SYS_MMC_ENV_DEV		0
 #define CONFIG_ENV_SIZE			0x2000
 #elif defined(CONFIG_SPIFLASH)
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SPI_BUS	0
 #define CONFIG_ENV_SPI_CS	0
 #define CONFIG_ENV_SPI_MAX_HZ	10000000
@@ -705,7 +686,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_ENV_SECT_SIZE	0x10000
 #define CONFIG_ENV_SIZE		0x2000
 #elif defined(CONFIG_NAND)
-#define CONFIG_ENV_IS_IN_NAND
 #ifdef CONFIG_TPL_BUILD
 #define CONFIG_ENV_SIZE		0x2000
 #define CONFIG_ENV_ADDR		(CONFIG_SYS_INIT_L2_ADDR + (160 << 10))
@@ -720,11 +700,9 @@ extern unsigned long get_sdram_size(void);
 #endif
 #define CONFIG_ENV_OFFSET	(1024 * 1024)
 #elif defined(CONFIG_SYS_RAMBOOT)
-#define CONFIG_ENV_IS_NOWHERE		/* Store ENV in memory only */
 #define CONFIG_ENV_ADDR			(CONFIG_SYS_MONITOR_BASE - 0x1000)
 #define CONFIG_ENV_SIZE			0x2000
 #else
-#define CONFIG_ENV_IS_IN_FLASH
 #define CONFIG_ENV_ADDR	(CONFIG_SYS_MONITOR_BASE - CONFIG_ENV_SECT_SIZE)
 #define CONFIG_ENV_SIZE		0x2000
 #define CONFIG_ENV_SECT_SIZE	0x20000 /* 128K (one sector) */
@@ -736,22 +714,12 @@ extern unsigned long get_sdram_size(void);
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_DATE
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
 #define CONFIG_CMD_REGINFO
 
 #undef CONFIG_WATCHDOG			/* watchdog disabled */
 
-#if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI) \
+#if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI_HCD) \
 		 || defined(CONFIG_FSL_SATA)
-#define CONFIG_DOS_PARTITION
-#endif
-
-/* Hash command with SHA acceleration supported in hardware */
-#ifdef CONFIG_FSL_CAAM
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
 #endif
 
 /*
@@ -803,8 +771,6 @@ extern unsigned long get_sdram_size(void);
 
 #undef  CONFIG_BOOTARGS		/* the boot command will set bootargs */
 
-#define CONFIG_BAUDRATE		115200
-
 #define	CONFIG_EXTRA_ENV_SETTINGS				\
 	"hwconfig=" __stringify(CONFIG_DEF_HWCONFIG)  "\0"	\
 	"netdev=eth0\0"						\