X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FMPC8569MDS.h;h=f50f53ec3fce074286cfbe802c08108bad89016d;hb=f9a48654ee70fbad29f487d074fd36a1548b4209;hp=ae92c37fe5bf160db2aaef60e6f2dcb624b48009;hpb=d021e942107a1f7304a879cec99286ca462f7be3;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/MPC8569MDS.h b/include/configs/MPC8569MDS.h
index ae92c37..f50f53e 100644
--- a/include/configs/MPC8569MDS.h
+++ b/include/configs/MPC8569MDS.h
@@ -1,7 +1,6 @@
+/* SPDX-License-Identifier: GPL-2.0+ */
 /*
  * Copyright 2009-2011 Freescale Semiconductor, Inc.
- *
- * SPDX-License-Identifier:	GPL-2.0+
  */
 
 /*
@@ -16,10 +15,7 @@
 #define CONFIG_PCIE1		1	/* PCIE controller */
 #define CONFIG_FSL_PCI_INIT	1	/* use common fsl pci init code */
 #define CONFIG_PCI_INDIRECT_BRIDGE 1	/* indirect PCI bridge support */
-#define CONFIG_FSL_PCIE_RESET	1	/* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT	1	/* enable 64-bit PCI resources */
-#define CONFIG_QE			/* Enable QE */
-#define CONFIG_ENV_OVERWRITE
 
 #ifndef __ASSEMBLY__
 extern unsigned long get_clock_freq(void);
@@ -48,12 +44,8 @@ extern unsigned long get_clock_freq(void);
  */
 #define CONFIG_ENABLE_36BIT_PHYS	1
 
-#define CONFIG_BOARD_EARLY_INIT_R	1
 #define CONFIG_HWCONFIG
 
-#define CONFIG_SYS_MEMTEST_START	0x00200000	/* memtest works on */
-#define CONFIG_SYS_MEMTEST_END		0x00400000
-
 /*
  * Config the L2 Cache as L2 SRAM
  */
@@ -70,7 +62,6 @@ extern unsigned long get_clock_freq(void);
 #endif
 
 /* DDR Setup */
-#undef CONFIG_FSL_DDR_INTERACTIVE
 #define CONFIG_SPD_EEPROM		/* Use SPD EEPROM for DDR setup*/
 #define CONFIG_DDR_SPD
 #define CONFIG_ECC_INIT_VIA_DDRCONTROLLER	/* DDR controller or DMA? */
@@ -117,8 +108,6 @@ extern unsigned long get_clock_freq(void);
 #define CONFIG_SYS_DDR_ERR_DIS          0x00000000
 #define CONFIG_SYS_DDR_SBE              0x00010000
 
-#undef CONFIG_CLOCKS_IN_MHZ
-
 /*
  * Local Bus Definitions
  */
@@ -153,8 +142,6 @@ extern unsigned long get_clock_freq(void);
 
 #undef CONFIG_SYS_RAMBOOT
 
-#define CONFIG_FLASH_CFI_DRIVER
-#define CONFIG_SYS_FLASH_CFI
 #define CONFIG_SYS_FLASH_EMPTY_INFO
 
 /* Chip select 3 - NAND */
@@ -214,7 +201,6 @@ extern unsigned long get_clock_freq(void);
 #define CONFIG_SYS_MALLOC_LEN	(512 * 1024)	/* Reserved for malloc */
 
 /* Serial Port */
-#define CONFIG_CONS_INDEX		1
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK		get_bus_freq(0)
@@ -407,8 +393,6 @@ extern unsigned long get_clock_freq(void);
 #endif /* CONFIG_QE */
 
 #if defined(CONFIG_PCI)
-#undef CONFIG_EEPRO100
-#undef CONFIG_TULIP
 
 #undef CONFIG_PCI_SCAN_SHOW		/* show pci devices on startup */
 
@@ -417,18 +401,11 @@ extern unsigned long get_clock_freq(void);
 /*
  * Environment
  */
-#if defined(CONFIG_SYS_RAMBOOT)
-#else
-#define CONFIG_ENV_ADDR		(CONFIG_SYS_MONITOR_BASE - CONFIG_ENV_SECT_SIZE)
-#define CONFIG_ENV_SECT_SIZE	0x20000	/* 128K(one sector) for env */
-#define CONFIG_ENV_SIZE		0x2000
-#endif
 
 #define CONFIG_LOADS_ECHO	1	/* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE	1	/* allow baudrate change */
 
 /* QE microcode/firmware address */
-#define CONFIG_SYS_QE_FMAN_FW_IN_NOR
 #define CONFIG_SYS_QE_FW_ADDR	0xfff00000
 
 /*
@@ -439,7 +416,6 @@ extern unsigned long get_clock_freq(void);
 #undef CONFIG_WATCHDOG			/* watchdog disabled */
 
 #ifdef CONFIG_MMC
-#define CONFIG_FSL_ESDHC
 #define CONFIG_FSL_ESDHC_PIN_MUX
 #define CONFIG_SYS_FSL_ESDHC_ADDR	CONFIG_SYS_MPC85xx_ESDHC_ADDR
 #endif
@@ -472,7 +448,7 @@ extern unsigned long get_clock_freq(void);
 /*
  * Environment Configuration
  */
-#define CONFIG_HOSTNAME mpc8569mds
+#define CONFIG_HOSTNAME "mpc8569mds"
 #define CONFIG_ROOTPATH  "/nfsroot"
 #define CONFIG_BOOTFILE  "your.uImage"