X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FMPC8548CDS.h;h=e73be48d5189402127be4e2b618d1963a0db4657;hb=6beacfcff81bdc04c10a440971b0fb683ee57534;hp=6acd54db8502686b207f80e385c00e16cfaeecba;hpb=f44483b57c49282299da0e5c10073b909cdad979;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/MPC8548CDS.h b/include/configs/MPC8548CDS.h
index 6acd54d..e73be48 100644
--- a/include/configs/MPC8548CDS.h
+++ b/include/configs/MPC8548CDS.h
@@ -13,6 +13,8 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
+#define CONFIG_DISPLAY_BOARDINFO
+
 #ifdef CONFIG_36BIT
 #define CONFIG_PHYS_64BIT
 #endif
@@ -20,7 +22,6 @@
 /* High Level Configuration Options */
 #define CONFIG_BOOKE		1	/* BOOKE */
 #define CONFIG_E500		1	/* BOOKE e500 family */
-#define CONFIG_MPC85xx		1	/* MPC8540/60/55/41/48 */
 #define CONFIG_MPC8548		1	/* MPC8548 specific */
 #define CONFIG_MPC8548CDS	1	/* MPC8548CDS board specific */
 
@@ -33,7 +34,7 @@
 
 #define CONFIG_PCI		/* enable any pci type devices */
 #define CONFIG_PCI1		/* PCI controller 1 */
-#define CONFIG_PCIE1		/* PCIE controler 1 (slot 1) */
+#define CONFIG_PCIE1		/* PCIE controller 1 (slot 1) */
 #undef CONFIG_PCI2
 #define CONFIG_FSL_PCI_INIT	1	/* Use common FSL init code */
 #define CONFIG_PCI_INDIRECT_BRIDGE 1	/* indirect PCI bridge support */
@@ -131,7 +132,6 @@ extern unsigned long get_clock_freq(void);
  *
  */
 
-
 /*
  * Local Bus Definitions
  */
@@ -320,7 +320,6 @@ extern unsigned long get_clock_freq(void);
 
 /* Serial Port */
 #define CONFIG_CONS_INDEX	2
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE	1
 #define CONFIG_SYS_NS16550_CLK		get_bus_freq(0)
@@ -331,14 +330,6 @@ extern unsigned long get_clock_freq(void);
 #define CONFIG_SYS_NS16550_COM1	(CONFIG_SYS_CCSRBAR+0x4500)
 #define CONFIG_SYS_NS16550_COM2	(CONFIG_SYS_CCSRBAR+0x4600)
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-
-/* pass open firmware flat tree */
-#define CONFIG_OF_LIBFDT		1
-#define CONFIG_OF_BOARD_SETUP		1
-#define CONFIG_OF_STDOUT_VIA_ALIAS	1
-
 /*
  * I2C
  */
@@ -424,13 +415,11 @@ extern unsigned long get_clock_freq(void);
 
 #undef CONFIG_EEPRO100
 #undef CONFIG_TULIP
-#define CONFIG_E1000			/* Define e1000 pci Ethernet card */
 
 #define CONFIG_PCI_SCAN_SHOW		/* show pci devices on startup */
 
 #endif	/* CONFIG_PCI */
 
-
 #if defined(CONFIG_TSEC_ENET)
 
 #define CONFIG_MII		1	/* MII PHY management */
@@ -488,25 +477,16 @@ extern unsigned long get_clock_freq(void);
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_HOSTNAME
 
-
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
-#define CONFIG_CMD_PING
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_IRQ
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_REGINFO
 
 #if defined(CONFIG_PCI)
     #define CONFIG_CMD_PCI
 #endif
 
-
 #undef CONFIG_WATCHDOG			/* watchdog disabled */
 
 /*
@@ -535,23 +515,16 @@ extern unsigned long get_clock_freq(void);
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE	230400	/* speed to run kgdb serial port */
-#define CONFIG_KGDB_SER_INDEX	2	/* which serial port to use */
 #endif
 
 /*
  * Environment Configuration
  */
-
-/* The mac addresses for all ethernet interface */
 #if defined(CONFIG_TSEC_ENET)
 #define CONFIG_HAS_ETH0
-#define CONFIG_ETHADDR	 00:E0:0C:00:00:FD
 #define CONFIG_HAS_ETH1
-#define CONFIG_ETH1ADDR	 00:E0:0C:00:01:FD
 #define CONFIG_HAS_ETH2
-#define CONFIG_ETH2ADDR	 00:E0:0C:00:02:FD
 #define CONFIG_HAS_ETH3
-#define CONFIG_ETH3ADDR	 00:E0:0C:00:03:FD
 #endif
 
 #define CONFIG_IPADDR	 192.168.1.253
@@ -567,7 +540,6 @@ extern unsigned long get_clock_freq(void);
 
 #define CONFIG_LOADADDR	1000000	/*default location for tftp and bootm*/
 
-#define CONFIG_BOOTDELAY 10	/* -1 disables auto-boot */
 #undef	CONFIG_BOOTARGS		/* the boot command will set bootargs*/
 
 #define CONFIG_BAUDRATE	115200
@@ -602,7 +574,6 @@ extern unsigned long get_clock_freq(void);
    "tftp $fdtaddr $fdtfile;"						\
    "bootm $loadaddr - $fdtaddr"
 
-
 #define CONFIG_RAMBOOTCOMMAND \
    "setenv bootargs root=/dev/ram rw "					\
       "console=$consoledev,$baudrate $othbootargs;"			\