X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FMPC8541CDS.h;h=6a400f577e05119c7a6fe259ff0ce72e3f7860c7;hb=0e8d158664a913392cb01fb11a948d83f72e105e;hp=33a153e3460621c92bec05e33c7cf6eb37d25bd2;hpb=3a79013e2adda53332dfd0b511066a805e929a9d;p=platform%2Fkernel%2Fu-boot.git diff --git a/include/configs/MPC8541CDS.h b/include/configs/MPC8541CDS.h index 33a153e..6a400f5 100644 --- a/include/configs/MPC8541CDS.h +++ b/include/configs/MPC8541CDS.h @@ -38,15 +38,12 @@ #define CONFIG_MPC8541CDS 1 /* MPC8541CDS board specific */ #define CONFIG_PCI -#define CONFIG_TSEC_ENET /* tsec ethernet support */ +#define CONFIG_TSEC_ENET /* tsec ethernet support */ #define CONFIG_ENV_OVERWRITE -#define CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup*/ -#define CONFIG_DDR_DLL /* possible DLL fix needed */ -#undef CONFIG_DDR_2T_TIMING /* Sets the 2T timing bit */ -#define CONFIG_DDR_ECC /* only for ECC DDR module */ -#define CONFIG_MEM_INIT_VALUE 0xDeadBeef +#define CONFIG_FSL_LAW 1 /* Use common FSL init code */ +#define CONFIG_FSL_VIA /* * When initializing flash, if we cannot find the manufacturer ID, @@ -55,8 +52,6 @@ */ #define CONFIG_ASSUME_AMD_FLASH -#define MPC85xx_DDR_SDRAM_CLK_CNTL /* 85xx has clock control reg */ - #ifndef __ASSEMBLY__ extern unsigned long get_clock_freq(void); #endif @@ -65,13 +60,10 @@ extern unsigned long get_clock_freq(void); /* * These can be toggled for performance analysis, otherwise use default. */ -#define CONFIG_L2_CACHE /* toggle L2 cache */ +#define CONFIG_L2_CACHE /* toggle L2 cache */ #define CONFIG_BTB /* toggle branch predition */ #define CONFIG_ADDR_STREAMING /* toggle addr streaming */ -#define CONFIG_BOARD_EARLY_INIT_F 1 /* Call board_pre_init */ - -#undef CFG_DRAM_TEST /* memory test, takes time */ #define CFG_MEMTEST_START 0x00200000 /* memtest works on */ #define CFG_MEMTEST_END 0x00400000 @@ -79,17 +71,28 @@ extern unsigned long get_clock_freq(void); * Base addresses -- Note these are effective addresses where the * actual resources get mapped (not physical addresses) */ -#define CFG_CCSRBAR_DEFAULT 0xff700000 /* CCSRBAR Default */ +#define CFG_CCSRBAR_DEFAULT 0xff700000 /* CCSRBAR Default */ #define CFG_CCSRBAR 0xe0000000 /* relocated CCSRBAR */ +#define CFG_CCSRBAR_PHYS CFG_CCSRBAR /* physical addr of CCSRBAR */ #define CFG_IMMR CFG_CCSRBAR /* PQII uses CFG_IMMR */ -/* - * DDR Setup - */ +/* DDR Setup */ +#define CONFIG_FSL_DDR1 +#define CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup*/ +#define CONFIG_DDR_SPD +#undef CONFIG_FSL_DDR_INTERACTIVE + +#define CONFIG_MEM_INIT_VALUE 0xDeadBeef + #define CFG_DDR_SDRAM_BASE 0x00000000 /* DDR is system memory*/ #define CFG_SDRAM_BASE CFG_DDR_SDRAM_BASE -#define SPD_EEPROM_ADDRESS 0x51 /* DDR DIMM */ +#define CONFIG_NUM_DDR_CONTROLLERS 1 +#define CONFIG_DIMM_SLOTS_PER_CTLR 1 +#define CONFIG_CHIP_SELECTS_PER_CTRL (2 * CONFIG_DIMM_SLOTS_PER_CTLR) + +/* I2C addresses of SPD EEPROMs */ +#define SPD_EEPROM_ADDRESS 0x51 /* CTLR 0 DIMM 0 */ /* * Make sure required options are set @@ -100,7 +103,6 @@ extern unsigned long get_clock_freq(void); #undef CONFIG_CLOCKS_IN_MHZ - /* * Local Bus Definitions */ @@ -150,9 +152,9 @@ extern unsigned long get_clock_freq(void); #define CFG_FLASH_ERASE_TOUT 60000 /* Flash Erase Timeout (ms) */ #define CFG_FLASH_WRITE_TOUT 500 /* Flash Write Timeout (ms) */ -#define CFG_MONITOR_BASE TEXT_BASE /* start of monitor */ +#define CFG_MONITOR_BASE TEXT_BASE /* start of monitor */ -#define CFG_FLASH_CFI_DRIVER +#define CONFIG_FLASH_CFI_DRIVER #define CFG_FLASH_CFI #define CFG_FLASH_EMPTY_INFO @@ -272,21 +274,23 @@ extern unsigned long get_clock_freq(void); * 1111 1111 1111 0000 0000 1111 1111 0111 = fff00ff7 */ +#define CONFIG_FSL_CADMUS + #define CADMUS_BASE_ADDR 0xf8000000 #define CFG_BR3_PRELIM 0xf8000801 #define CFG_OR3_PRELIM 0xfff00ff7 #define CONFIG_L1_INIT_RAM -#define CFG_INIT_RAM_LOCK 1 +#define CFG_INIT_RAM_LOCK 1 #define CFG_INIT_RAM_ADDR 0xe4010000 /* Initial RAM address */ -#define CFG_INIT_RAM_END 0x4000 /* End of used area in RAM */ +#define CFG_INIT_RAM_END 0x4000 /* End of used area in RAM */ -#define CFG_GBL_DATA_SIZE 128 /* num bytes initial data */ +#define CFG_GBL_DATA_SIZE 128 /* num bytes initial data */ #define CFG_GBL_DATA_OFFSET (CFG_INIT_RAM_END - CFG_GBL_DATA_SIZE) #define CFG_INIT_SP_OFFSET CFG_GBL_DATA_OFFSET -#define CFG_MONITOR_LEN (256 * 1024) /* Reserve 256 kB for Mon */ -#define CFG_MALLOC_LEN (128 * 1024) /* Reserved for malloc */ +#define CFG_MONITOR_LEN (256 * 1024) /* Reserve 256 kB for Mon */ +#define CFG_MALLOC_LEN (128 * 1024) /* Reserved for malloc */ /* Serial Port */ #define CONFIG_CONS_INDEX 2 @@ -309,16 +313,12 @@ extern unsigned long get_clock_freq(void); #endif /* pass open firmware flat tree */ -#define CONFIG_OF_FLAT_TREE 1 -#define CONFIG_OF_BOARD_SETUP 1 - -/* maximum size of the flat tree (8K) */ -#define OF_FLAT_TREE_MAX_SIZE 8192 +#define CONFIG_OF_LIBFDT 1 +#define CONFIG_OF_BOARD_SETUP 1 +#define CONFIG_OF_STDOUT_VIA_ALIAS 1 -#define OF_CPU "PowerPC,8541@0" -#define OF_SOC "soc8541@e0000000" -#define OF_TBCLK (bd->bi_busfreq / 8) -#define OF_STDOUT_PATH "/soc8541@e0000000/serial@4600" +#define CFG_64BIT_VSPRINTF 1 +#define CFG_64BIT_STRTOUL 1 /* * I2C @@ -327,11 +327,17 @@ extern unsigned long get_clock_freq(void); #define CONFIG_HARD_I2C /* I2C with hardware support*/ #undef CONFIG_SOFT_I2C /* I2C bit-banged */ #define CFG_I2C_SPEED 400000 /* I2C speed and slave address */ -#define CFG_I2C_EEPROM_ADDR 0x57 #define CFG_I2C_SLAVE 0x7F #define CFG_I2C_NOPROBES {0x69} /* Don't probe these addrs */ #define CFG_I2C_OFFSET 0x3000 +/* EEPROM */ +#define CONFIG_ID_EEPROM +#define CFG_I2C_EEPROM_CCID +#define CFG_ID_EEPROM +#define CFG_I2C_EEPROM_ADDR 0x57 +#define CFG_I2C_EEPROM_ADDR_LEN 2 + /* * General PCI * Memory space is mapped 1-1, but I/O space must start from 0. @@ -362,7 +368,7 @@ extern unsigned long get_clock_freq(void); #define CONFIG_MPC85XX_PCI2 #define CONFIG_NET_MULTI -#define CONFIG_PCI_PNP /* do pci plug-and-play */ +#define CONFIG_PCI_PNP /* do pci plug-and-play */ #undef CONFIG_EEPRO100 #undef CONFIG_TULIP @@ -376,7 +382,7 @@ extern unsigned long get_clock_freq(void); #if defined(CONFIG_TSEC_ENET) #ifndef CONFIG_NET_MULTI -#define CONFIG_NET_MULTI 1 +#define CONFIG_NET_MULTI 1 #endif #define CONFIG_MII 1 /* MII PHY management */ @@ -399,10 +405,10 @@ extern unsigned long get_clock_freq(void); /* * Environment */ -#define CFG_ENV_IS_IN_FLASH 1 -#define CFG_ENV_ADDR (CFG_MONITOR_BASE + 0x40000) -#define CFG_ENV_SECT_SIZE 0x40000 /* 256K(one sector) for env */ -#define CFG_ENV_SIZE 0x2000 +#define CONFIG_ENV_IS_IN_FLASH 1 +#define CONFIG_ENV_ADDR (CFG_MONITOR_BASE + 0x40000) +#define CONFIG_ENV_SECT_SIZE 0x40000 /* 256K(one sector) for env */ +#define CONFIG_ENV_SIZE 0x2000 #define CONFIG_LOADS_ECHO 1 /* echo on for serial download */ #define CFG_LOADS_BAUD_CHANGE 1 /* allow baudrate change */ @@ -424,6 +430,7 @@ extern unsigned long get_clock_freq(void); #define CONFIG_CMD_PING #define CONFIG_CMD_I2C #define CONFIG_CMD_MII +#define CONFIG_CMD_ELF #if defined(CONFIG_PCI) #define CONFIG_CMD_PCI @@ -436,6 +443,7 @@ extern unsigned long get_clock_freq(void); * Miscellaneous configurable options */ #define CFG_LONGHELP /* undef to save memory */ +#define CONFIG_CMDLINE_EDITING /* Command-line editing */ #define CFG_LOAD_ADDR 0x2000000 /* default load address */ #define CFG_PROMPT "=> " /* Monitor Command Prompt */ #if defined(CONFIG_CMD_KGDB) @@ -453,14 +461,7 @@ extern unsigned long get_clock_freq(void); * have to be in the first 8 MB of memory, since this is * the maximum mapped by the Linux kernel during initialization. */ -#define CFG_BOOTMAPSZ (8 << 20) /* Initial Memory map for Linux*/ - -/* Cache Configuration */ -#define CFG_DCACHE_SIZE 32768 -#define CFG_CACHELINE_SIZE 32 -#if defined(CONFIG_CMD_KGDB) -#define CFG_CACHELINE_SHIFT 5 /*log base 2 of the above value*/ -#endif +#define CFG_BOOTMAPSZ (8 << 20) /* Initial Memory map for Linux*/ /* * Internal Definitions @@ -481,6 +482,7 @@ extern unsigned long get_clock_freq(void); /* The mac addresses for all ethernet interface */ #if defined(CONFIG_TSEC_ENET) +#define CONFIG_HAS_ETH0 #define CONFIG_ETHADDR 00:E0:0C:00:00:FD #define CONFIG_HAS_ETH1 #define CONFIG_ETH1ADDR 00:E0:0C:00:01:FD