X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FMPC8540ADS.h;h=3389a77bc1e144c21971ceb71d31db0b00c95076;hb=0ff27d4a94637d4b1937c625d33212375bd118d9;hp=921180f2094d63e64f2f5d7d65f5d76c2d77b102;hpb=c1924d85af4a07dc70aef1ef95c48b54a136733f;p=platform%2Fkernel%2Fu-boot.git diff --git a/include/configs/MPC8540ADS.h b/include/configs/MPC8540ADS.h index 921180f..3389a77 100644 --- a/include/configs/MPC8540ADS.h +++ b/include/configs/MPC8540ADS.h @@ -18,14 +18,6 @@ #ifndef __CONFIG_H #define __CONFIG_H -#define CONFIG_DISPLAY_BOARDINFO - -/* High Level Configuration Options */ -#define CONFIG_BOOKE 1 /* BOOKE */ -#define CONFIG_E500 1 /* BOOKE e500 family */ -#define CONFIG_MPC8540 1 /* MPC8540 specific */ -#define CONFIG_MPC8540ADS 1 /* MPC8540ADS board specific */ - /* * default CCARBAR is at 0xff700000 * assume U-Boot is less than 0.5MB @@ -36,12 +28,10 @@ #define CONFIG_HAS_FEC 1 /* 8540 has FEC */ #endif -#define CONFIG_PCI #define CONFIG_PCI_INDIRECT_BRIDGE #define CONFIG_SYS_PCI_64BIT 1 /* enable 64-bit PCI resources */ #define CONFIG_TSEC_ENET /* tsec ethernet support */ #define CONFIG_ENV_OVERWRITE -#define CONFIG_FSL_LAW 1 /* Use common FSL init code */ /* * sysclk for MPC85xx @@ -65,7 +55,6 @@ #define CONFIG_SYS_CLK_FREQ 33000000 #endif - /* * These can be toggled for performance analysis, otherwise use default. */ @@ -79,7 +68,6 @@ #define CONFIG_SYS_CCSRBAR_PHYS_LOW CONFIG_SYS_CCSRBAR /* DDR Setup */ -#define CONFIG_SYS_FSL_DDR1 #define CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup*/ #define CONFIG_DDR_SPD #undef CONFIG_FSL_DDR_INTERACTIVE @@ -89,7 +77,6 @@ #define CONFIG_SYS_DDR_SDRAM_BASE 0x00000000 /* DDR is system memory*/ #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE -#define CONFIG_NUM_DDR_CONTROLLERS 1 #define CONFIG_DIMM_SLOTS_PER_CTLR 1 #define CONFIG_CHIP_SELECTS_PER_CTRL (2 * CONFIG_DIMM_SLOTS_PER_CTLR) @@ -136,7 +123,6 @@ #undef CONFIG_CLOCKS_IN_MHZ - /* * Local Bus Definitions */ @@ -201,7 +187,6 @@ #define CONFIG_SYS_LBC_LSDMR_4 (CONFIG_SYS_LBC_LSDMR_COMMON | LSDMR_OP_MRW) #define CONFIG_SYS_LBC_LSDMR_5 (CONFIG_SYS_LBC_LSDMR_COMMON | LSDMR_OP_NORMAL) - /* * 32KB, 8-bit wide for ADS config reg */ @@ -231,16 +216,6 @@ #define CONFIG_SYS_NS16550_COM1 (CONFIG_SYS_CCSRBAR+0x4500) #define CONFIG_SYS_NS16550_COM2 (CONFIG_SYS_CCSRBAR+0x4600) -/* Use the HUSH parser */ -#define CONFIG_SYS_HUSH_PARSER -#ifdef CONFIG_SYS_HUSH_PARSER -#endif - -/* pass open firmware flat tree */ -#define CONFIG_OF_LIBFDT 1 -#define CONFIG_OF_BOARD_SETUP 1 -#define CONFIG_OF_STDOUT_VIA_ALIAS 1 - /* * I2C */ @@ -271,9 +246,6 @@ #define CONFIG_SYS_PCI1_IO_SIZE 0x100000 /* 1M */ #if defined(CONFIG_PCI) - -#define CONFIG_PCI_PNP /* do pci plug-and-play */ - #undef CONFIG_EEPRO100 #undef CONFIG_TULIP @@ -288,7 +260,6 @@ #endif /* CONFIG_PCI */ - #if defined(CONFIG_TSEC_ENET) #define CONFIG_MII 1 /* MII PHY management */ @@ -303,7 +274,6 @@ #define TSEC1_FLAGS TSEC_GIGABIT #define TSEC2_FLAGS TSEC_GIGABIT - #if CONFIG_HAS_FEC #define CONFIG_MPC85XX_FEC 1 #define CONFIG_MPC85XX_FEC_NAME "FEC" @@ -317,7 +287,6 @@ #endif /* CONFIG_TSEC_ENET */ - /* * Environment */ @@ -336,7 +305,6 @@ #define CONFIG_LOADS_ECHO 1 /* echo on for serial download */ #define CONFIG_SYS_LOADS_BAUD_CHANGE 1 /* allow baudrate change */ - /* * BOOTP options */ @@ -345,12 +313,9 @@ #define CONFIG_BOOTP_GATEWAY #define CONFIG_BOOTP_HOSTNAME - /* * Command line configuration. */ -#define CONFIG_CMD_PING -#define CONFIG_CMD_I2C #define CONFIG_CMD_IRQ #if defined(CONFIG_PCI) @@ -389,7 +354,6 @@ #define CONFIG_KGDB_BAUDRATE 230400 /* speed to run kgdb serial port */ #endif - /* * Environment Configuration */ @@ -413,7 +377,6 @@ #define CONFIG_LOADADDR 200000 /* default location for tftp and bootm */ -#define CONFIG_BOOTDELAY 10 /* -1 disables auto-boot */ #undef CONFIG_BOOTARGS /* the boot command will set bootargs */ #define CONFIG_BAUDRATE 115200