X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FMPC8536DS.h;h=b536f6764e830d69a7b1c49826e6c62e0deaccfe;hb=bb6b142fc16713bb83e471912e614ac01eec4584;hp=d41eeb59b6f7beee4f78cc0e1c9479cdac9bdeee;hpb=92ac520821405e196c920d60921bdfa5ab6b878c;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/MPC8536DS.h b/include/configs/MPC8536DS.h
index d41eeb5..b536f67 100644
--- a/include/configs/MPC8536DS.h
+++ b/include/configs/MPC8536DS.h
@@ -11,14 +11,9 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-#define CONFIG_SYS_GENERIC_BOARD
 #define CONFIG_DISPLAY_BOARDINFO
 #include "../board/freescale/common/ics307_clk.h"
 
-#ifdef CONFIG_36BIT
-#define CONFIG_PHYS_64BIT	1
-#endif
-
 #ifdef CONFIG_SDCARD
 #define CONFIG_RAMBOOT_SDCARD		1
 #define CONFIG_SYS_TEXT_BASE	0xf8f40000
@@ -50,19 +45,17 @@
 #define CONFIG_MPC8536DS	1
 
 #define CONFIG_FSL_ELBC		1	/* Has Enhanced localbus controller */
-#define CONFIG_SPI_FLASH	1	/* Has SPI Flash */
 #define CONFIG_PCI		1	/* Enable PCI/PCIE */
 #define CONFIG_PCI1		1	/* Enable PCI controller 1 */
-#define CONFIG_PCIE1		1	/* PCIE controler 1 (slot 1) */
-#define CONFIG_PCIE2		1	/* PCIE controler 2 (slot 2) */
-#define CONFIG_PCIE3		1	/* PCIE controler 3 (ULI bridge) */
+#define CONFIG_PCIE1		1	/* PCIE controller 1 (slot 1) */
+#define CONFIG_PCIE2		1	/* PCIE controller 2 (slot 2) */
+#define CONFIG_PCIE3		1	/* PCIE controller 3 (ULI bridge) */
 #define CONFIG_FSL_PCI_INIT	1	/* Use common FSL init code */
 #define CONFIG_PCI_INDIRECT_BRIDGE 1	/* indirect PCI bridge support */
 #define CONFIG_FSL_PCIE_RESET	1	/* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT	1	/* enable 64-bit PCI resources */
 
 #define CONFIG_FSL_LAW		1	/* Use common FSL init code */
-#define CONFIG_E1000		1	/* Defind e1000 pci Ethernet card*/
 
 #define CONFIG_TSEC_ENET		/* tsec ethernet support */
 #define CONFIG_ENV_OVERWRITE
@@ -159,7 +152,6 @@
 
 #undef CONFIG_CLOCKS_IN_MHZ
 
-
 /*
  * Memory map -- xxx -this is wrong, needs updating
  *
@@ -371,7 +363,6 @@
  * shorted - index 1
  */
 #define CONFIG_CONS_INDEX	1
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE	1
 #define CONFIG_SYS_NS16550_CLK		get_bus_freq(0)
@@ -385,16 +376,6 @@
 #define CONFIG_SYS_NS16550_COM1	(CONFIG_SYS_CCSRBAR + 0x4500)
 #define CONFIG_SYS_NS16550_COM2	(CONFIG_SYS_CCSRBAR + 0x4600)
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-
-/*
- * Pass open firmware flat tree
- */
-#define CONFIG_OF_LIBFDT		1
-#define CONFIG_OF_BOARD_SETUP		1
-#define CONFIG_OF_STDOUT_VIA_ALIAS	1
-
 /*
  * I2C
  */
@@ -423,11 +404,8 @@
  * eSPI - Enhanced SPI
  */
 #define CONFIG_HARD_SPI
-#define CONFIG_FSL_ESPI
 
 #if defined(CONFIG_SPI_FLASH)
-#define CONFIG_SPI_FLASH_SPANSION
-#define CONFIG_CMD_SF
 #define CONFIG_SF_DEFAULT_SPEED	10000000
 #define CONFIG_SF_DEFAULT_MODE	0
 #endif
@@ -535,13 +513,11 @@
 #define CONFIG_VGA_AS_SINGLE_DEVICE
 #define CONFIG_ATI_RADEON_FB
 #define CONFIG_VIDEO_LOGO
-/*#define CONFIG_CONSOLE_CURSOR*/
 #define CONFIG_SYS_ISA_IO_BASE_ADDRESS CONFIG_SYS_PCIE3_IO_VIRT
 #endif
 
 #undef CONFIG_EEPRO100
 #undef CONFIG_TULIP
-#undef CONFIG_RTL8139
 
 #ifndef CONFIG_PCI_PNP
 	#define PCI_ENET0_IOADDR	CONFIG_SYS_PCI1_IO_BUS
@@ -569,7 +545,6 @@
 #define CONFIG_LBA48
 #define CONFIG_CMD_SATA
 #define CONFIG_DOS_PARTITION
-#define CONFIG_CMD_EXT2
 #endif
 
 #if defined(CONFIG_TSEC_ENET)
@@ -636,20 +611,12 @@
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_IRQ
-#define CONFIG_CMD_PING
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_IRQ
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_REGINFO
 
 #if defined(CONFIG_PCI)
 #define CONFIG_CMD_PCI
-#define CONFIG_CMD_NET
 #endif
 
 #undef CONFIG_WATCHDOG			/* watchdog disabled */
@@ -659,7 +626,6 @@
 #ifdef CONFIG_MMC
 #define CONFIG_FSL_ESDHC
 #define CONFIG_SYS_FSL_ESDHC_ADDR	CONFIG_SYS_MPC85xx_ESDHC_ADDR
-#define CONFIG_CMD_MMC
 #define CONFIG_GENERIC_MMC
 #endif
 
@@ -671,7 +637,6 @@
 #define CONFIG_USB_EHCI
 
 #ifdef CONFIG_USB_EHCI
-#define CONFIG_CMD_USB
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_USB_STORAGE
@@ -679,8 +644,6 @@
 #endif
 
 #if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI)
-#define CONFIG_CMD_EXT2
-#define CONFIG_CMD_FAT
 #define CONFIG_DOS_PARTITION
 #endif
 
@@ -739,7 +702,6 @@
 /* default location for tftp and bootm */
 #define CONFIG_LOADADDR		1000000
 
-#define CONFIG_BOOTDELAY 10	/* -1 disables auto-boot */
 #undef  CONFIG_BOOTARGS		/* the boot command will set bootargs */
 
 #define CONFIG_BAUDRATE	115200
@@ -761,7 +723,7 @@
 "consoledev=ttyS0\0"				\
 "ramdiskaddr=2000000\0"			\
 "ramdiskfile=8536ds/ramdisk.uboot\0"		\
-"fdtaddr=c00000\0"				\
+"fdtaddr=1e00000\0"				\
 "fdtfile=8536ds/mpc8536ds.dtb\0"		\
 "bdev=sda3\0"					\
 "hwconfig=usb1:dr_mode=host,phy_type=ulpi\0"