X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FBSC9132QDS.h;h=108e92494d5b562ef9d0751e776151e8a25b0c46;hb=e16e137c377c8b96d8d91263d0b6d8470169f841;hp=989363c0fbc0def810b96a73ae07889382205656;hpb=03a3536c7b7f2902932606da9248c6f08318174a;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/BSC9132QDS.h b/include/configs/BSC9132QDS.h
index 989363c..108e924 100644
--- a/include/configs/BSC9132QDS.h
+++ b/include/configs/BSC9132QDS.h
@@ -11,6 +11,8 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
+#define CONFIG_DISPLAY_BOARDINFO
+
 #ifdef CONFIG_BSC9132QDS
 #define CONFIG_BSC9132
 #endif
@@ -89,10 +91,8 @@
 #define CONFIG_FSL_PCIE_RESET		/* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT		/* enable 64-bit PCI resources */
 
-#define CONFIG_CMD_NET
 #define CONFIG_CMD_PCI
 
-#define CONFIG_E1000			/*  E1000 pci Ethernet card*/
 
 /*
  * PCI Windows
@@ -317,7 +317,6 @@ combinations. this should be removed later
 /* NAND */
 #define CONFIG_SYS_NAND_BASE_LIST	{ CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE	1
-#define CONFIG_MTD_NAND_VERIFY_WRITE
 #define CONFIG_CMD_NAND
 
 #define CONFIG_SYS_NAND_BLOCK_SIZE	(128 * 1024)
@@ -397,9 +396,9 @@ combinations. this should be removed later
 
 #define CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR	0xffd00000	/* stack in RAM */
-#define CONFIG_SYS_INIT_RAM_END		0x00004000 /* End of used area in RAM */
+#define CONFIG_SYS_INIT_RAM_SIZE	0x00004000 /* End of used area in RAM */
 
-#define CONFIG_SYS_GBL_DATA_OFFSET	(CONFIG_SYS_INIT_RAM_END \
+#define CONFIG_SYS_GBL_DATA_OFFSET	(CONFIG_SYS_INIT_RAM_SIZE \
 						- GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET	CONFIG_SYS_GBL_DATA_OFFSET
 
@@ -409,7 +408,6 @@ combinations. this should be removed later
 /* Serial Port */
 #define CONFIG_CONS_INDEX	1
 #undef	CONFIG_SERIAL_SOFTWARE_FIFO
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE	1
 #define CONFIG_SYS_NS16550_CLK		get_bus_freq(0)
@@ -417,7 +415,6 @@ combinations. this should be removed later
 #define CONFIG_NS16550_MIN_FUNCTIONS
 #endif
 
-#define CONFIG_SERIAL_MULTI	1 /* Enable both serial ports */
 #define CONFIG_SYS_CONSOLE_IS_IN_ENV	/* determine from environment */
 
 #define CONFIG_SYS_BAUDRATE_TABLE	\
@@ -434,17 +431,6 @@ combinations. this should be removed later
 #define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
 #endif
 
-/*
- * Pass open firmware flat tree
- */
-#define CONFIG_OF_LIBFDT
-#define CONFIG_OF_BOARD_SETUP
-#define CONFIG_OF_STDOUT_VIA_ALIAS
-
-/* new uImage format support */
-#define CONFIG_FIT
-#define CONFIG_FIT_VERBOSE	/* enable fit_format_{error,warning}() */
-
 #define CONFIG_SYS_I2C
 #define CONFIG_SYS_I2C_FSL
 #define CONFIG_SYS_FSL_I2C_SPEED	400800 /* I2C speed and slave address*/
@@ -465,7 +451,6 @@ combinations. this should be removed later
 
 /* enable read and write access to EEPROM */
 #define CONFIG_CMD_EEPROM
-#define CONFIG_SYS_I2C_MULTI_EEPROMS
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -482,10 +467,7 @@ combinations. this should be removed later
  * used for SLIC
  */
 /* eSPI - Enhanced SPI */
-#define CONFIG_FSL_ESPI  /* SPI */
 #ifdef CONFIG_FSL_ESPI
-#define CONFIG_SPI_FLASH
-#define CONFIG_SPI_FLASH_SPANSION
 #define CONFIG_CMD_SF
 #define CONFIG_SF_DEFAULT_SPEED		10000000
 #define CONFIG_SF_DEFAULT_MODE		SPI_MODE_0
@@ -580,17 +562,13 @@ combinations. this should be removed later
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_DATE
 #define CONFIG_CMD_DHCP
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_PING
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_REGINFO
 
 #if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI)
@@ -637,6 +615,27 @@ combinations. this should be removed later
 #endif
 
 /*
+ * Dynamic MTD Partition support with mtdparts
+ */
+#ifndef CONFIG_SYS_NO_FLASH
+#define CONFIG_MTD_DEVICE
+#define CONFIG_MTD_PARTITIONS
+#define CONFIG_CMD_MTDPARTS
+#define CONFIG_FLASH_CFI_MTD
+#define MTDIDS_DEFAULT "nor0=88000000.nor,nand0=ff800000.flash,"
+#define MTDPARTS_DEFAULT "mtdparts=88000000.nor:256k(dtb),7m(kernel)," \
+			"55m(fs),1m(uboot);ff800000.flash:1m(uboot)," \
+			"8m(kernel),512k(dtb),-(fs)"
+#endif
+/*
+ * Override partitions in device tree using info
+ * in "mtdparts" environment variable
+ */
+#ifdef CONFIG_CMD_MTDPARTS
+#define CONFIG_FDT_FIXUP_PARTITIONS
+#endif
+
+/*
  * Environment Configuration
  */
 
@@ -651,6 +650,7 @@ combinations. this should be removed later
 #define CONFIG_UBOOTPATH	"u-boot.bin"
 
 #define CONFIG_BAUDRATE		115200
+#define CONFIG_BOOTDELAY	10 /* -1 disable auto-boot */
 
 #ifdef CONFIG_SDCARD
 #define CONFIG_DEF_HWCONFIG	"hwconfig=usb1:dr_mode=host,phy_type=ulpi\0"
@@ -711,8 +711,4 @@ combinations. this should be removed later
 
 #include <asm/fsl_secure_boot.h>
 
-#ifdef CONFIG_SECURE_BOOT
-#define CONFIG_CMD_BLOB
-#endif
-
 #endif	/* __CONFIG_H */