X-Git-Url: http://review.tizen.org/git/?a=blobdiff_plain;f=include%2Fconfigs%2FBSC9131RDB.h;h=59b2252e6fc866cbd2f463d6d83bfbf6294be2e2;hb=5b8e76c35ec312a3f73126bd1a2d2c0965b98a9f;hp=f2a7c69ad2c72d5a422aa89cf477bcca05a681a4;hpb=c6f086ddcbfb47918b82f6a135c61f432540da42;p=platform%2Fkernel%2Fu-boot.git

diff --git a/include/configs/BSC9131RDB.h b/include/configs/BSC9131RDB.h
index f2a7c69..59b2252 100644
--- a/include/configs/BSC9131RDB.h
+++ b/include/configs/BSC9131RDB.h
@@ -11,12 +11,7 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-#define CONFIG_DISPLAY_BOARDINFO
-
-#ifdef CONFIG_BSC9131RDB
-#define CONFIG_BSC9131
 #define CONFIG_NAND_FSL_IFC
-#endif
 
 #ifdef CONFIG_SPIFLASH
 #define CONFIG_RAMBOOT_SPIFLASH
@@ -28,8 +23,6 @@
 
 #ifdef CONFIG_NAND
 #define CONFIG_SPL_INIT_MINIMAL
-#define CONFIG_SPL_SERIAL_SUPPORT
-#define CONFIG_SPL_NAND_SUPPORT
 #define CONFIG_SPL_NAND_BOOT
 #define CONFIG_SPL_FLUSH_IMAGE
 #define CONFIG_SPL_TARGET		"u-boot-with-spl.bin"
@@ -53,12 +46,7 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_BOOKE			/* BOOKE */
-#define CONFIG_E500			/* BOOKE e500 family */
-#define CONFIG_FSL_IFC			/* Enable IFC Support */
-#define CONFIG_FSL_CAAM			/* Enable SEC/CAAM */
 
-#define CONFIG_FSL_LAW			/* Use common FSL init code */
 #define CONFIG_TSEC_ENET
 #define CONFIG_ENV_OVERWRITE
 
@@ -80,7 +68,6 @@
 #define CONFIG_SYS_MEMTEST_END		0x01ffffff
 
 /* DDR Setup */
-#define CONFIG_SYS_FSL_DDR3
 #undef CONFIG_SYS_DDR_RAW_TIMING
 #undef CONFIG_DDR_SPD
 #define CONFIG_SYS_SPD_BUS_NUM		0
@@ -95,7 +82,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_DDR_SDRAM_BASE	0x00000000
 #define CONFIG_SYS_SDRAM_BASE		CONFIG_SYS_DDR_SDRAM_BASE
 
-#define CONFIG_NUM_DDR_CONTROLLERS	1
 #define CONFIG_DIMM_SLOTS_PER_CTLR	1
 #define CONFIG_CHIP_SELECTS_PER_CTRL	1
 
@@ -160,7 +146,6 @@ extern unsigned long get_sdram_size(void);
 /*
  * IFC Definitions
  */
-#define CONFIG_SYS_NO_FLASH
 
 /* NAND Flash on IFC */
 #define CONFIG_SYS_NAND_BASE		0xff800000
@@ -210,8 +195,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_CS0_FTIM2		CONFIG_SYS_NAND_FTIM2
 #define CONFIG_SYS_CS0_FTIM3		CONFIG_SYS_NAND_FTIM3
 
-#define CONFIG_BOARD_EARLY_INIT_F	/* Call board_pre_init */
-
 #define CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR	0xffd00000	/* stack in RAM */
 #define CONFIG_SYS_INIT_RAM_SIZE	0x00004000/* End of used area in RAM */
@@ -233,8 +216,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_NS16550_MIN_FUNCTIONS
 #endif
 
-#define CONFIG_SYS_CONSOLE_IS_IN_ENV	/* determine from environment */
-
 #define CONFIG_SYS_BAUDRATE_TABLE	\
 	{300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200}
 
@@ -247,7 +228,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_FSL_I2C_OFFSET	0x3000
 
 /* I2C EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -313,9 +293,6 @@ extern unsigned long get_sdram_size(void);
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
-#define CONFIG_DOS_PARTITION
 #define CONFIG_CMD_REGINFO
 
 /*
@@ -348,18 +325,9 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_KGDB_BAUDRATE	230400	/* speed to run kgdb serial port */
 #endif
 
-/* Hash command with SHA acceleration supported in hardware */
-#ifdef CONFIG_FSL_CAAM
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
-#endif
-
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
-#define CONFIG_USB_STORAGE
 #define CONFIG_HAS_FSL_DR_USB
 #endif
 
@@ -372,13 +340,6 @@ extern unsigned long get_sdram_size(void);
 #define MTDIDS_DEFAULT "nand0=ff800000.flash,"
 #define MTDPARTS_DEFAULT "mtdparts=ff800000.flash:1m(uboot)," \
 			"8m(kernel),512k(dtb),-(fs)"
-/*
- * Override partitions in device tree using info
- * in "mtdparts" environment variable
- */
-#ifdef CONFIG_CMD_MTDPARTS
-#define CONFIG_FDT_FIXUP_PARTITIONS
-#endif
 
 /*
  * Environment Configuration
@@ -393,8 +354,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_BOOTFILE		"uImage"
 #define CONFIG_UBOOTPATH	"u-boot.bin" /* U-Boot image on TFTP server */
 
-#define CONFIG_BAUDRATE		115200
-
 #define	CONFIG_EXTRA_ENV_SETTINGS				\
 	"netdev=eth0\0"						\
 	"uboot=" CONFIG_UBOOTPATH "\0"				\