* @iobase: The base address of the hardware registers
* @enetaddr: The Ethernet MAC address that is loaded from EEPROM or env
* @phy_interface: PHY interface to use - see PHY_INTERFACE_MODE_...
+ * @max_speed: Maximum speed of Ethernet connection supported by MAC
*/
struct eth_pdata {
phys_addr_t iobase;
unsigned char enetaddr[6];
int phy_interface;
+ int max_speed;
};
enum eth_recv_flags {
extern struct eth_device *eth_current;
-static inline __attribute__((always_inline))
-struct eth_device *eth_get_dev(void)
+static __always_inline struct eth_device *eth_get_dev(void)
{
return eth_current;
}
/* Used only when NetConsole is enabled */
int eth_is_active(struct eth_device *dev); /* Test device for active state */
/* Set active state */
-static inline __attribute__((always_inline)) int eth_init_state_only(void)
+static __always_inline int eth_init_state_only(void)
{
eth_get_dev()->state = ETH_STATE_ACTIVE;
return 0;
}
/* Set passive state */
-static inline __attribute__((always_inline)) void eth_halt_state_only(void)
+static __always_inline void eth_halt_state_only(void)
{
eth_get_dev()->state = ETH_STATE_PASSIVE;
}
int eth_getenv_enetaddr(const char *name, uchar *enetaddr);
int eth_setenv_enetaddr(const char *name, const uchar *enetaddr);
+/**
+ * eth_setenv_enetaddr_by_index() - set the MAC address envrionment variable
+ *
+ * This sets up an environment variable with the given MAC address (@enetaddr).
+ * The environment variable to be set is defined by <@base_name><@index>addr.
+ * If @index is 0 it is omitted. For common Ethernet this means ethaddr,
+ * eth1addr, etc.
+ *
+ * @base_name: Base name for variable, typically "eth"
+ * @index: Index of interface being updated (>=0)
+ * @enetaddr: Pointer to MAC address to put into the variable
+ * @return 0 if OK, other value on error
+ */
+int eth_setenv_enetaddr_by_index(const char *base_name, int index,
+ uchar *enetaddr);
+
+
/*
* Get the hardware address for an ethernet interface .
* Args:
#define PROT_ARP 0x0806 /* IP ARP protocol */
#define PROT_RARP 0x8035 /* IP ARP protocol */
#define PROT_VLAN 0x8100 /* IEEE 802.1q protocol */
+#define PROT_IPV6 0x86dd /* IPv6 over bluebook */
+#define PROT_PPP_SES 0x8864 /* PPPoE session messages */
#define IPPROTO_ICMP 1 /* Internet Control Message Protocol */
#define IPPROTO_UDP 17 /* User Datagram Protocol */
unsigned src_port, unsigned len);
#endif
-static inline __attribute__((always_inline)) int eth_is_on_demand_init(void)
+static __always_inline int eth_is_on_demand_init(void)
{
#ifdef CONFIG_NETCONSOLE
extern enum proto_t net_loop_last_protocol;