Rename CONFIG_SYS_INIT_RAM_END into CONFIG_SYS_INIT_RAM_SIZE

[platform/kernel/u-boot.git] / include / configs / zeus.h

diff --git a/include/configs/zeus.h b/include/configs/zeus.h
index aa250cc..d24ea0b 100644 (file)
--- a/include/configs/zeus.h
+++ b/include/configs/zeus.h
@@ -34,6 +34,8 @@
 #define CONFIG_4xx             1               /* ... PPC4xx family    */
 #define CONFIG_405EP           1               /* Specifc 405EP support*/
 
+#define        CONFIG_SYS_TEXT_BASE    0xFFFC0000
+
 #define CONFIG_SYS_CLK_FREQ     33000000 /* external frequency to pll   */
 
 #define CONFIG_BOARD_EARLY_INIT_F 1            /* Call board_early_init_f */
@@ -94,7 +96,7 @@
 #define CONFIG_SYS_POST_ETHER_EXT_LOOPBACK     /* eth POST using ext loopack connector */
 
 /* Define here the base-addresses of the UARTs to test in POST */
-#define CONFIG_SYS_POST_UART_TABLE     {UART0_BASE}
+#define CONFIG_SYS_POST_UART_TABLE     { CONFIG_SYS_NS16550_COM1 }
 
 #define CONFIG_LOGBUFFER
 #define CONFIG_SYS_POST_CACHE_ADDR     0x00800000 /* free virtual address      */
@@ -251,10 +253,10 @@
 #define CONFIG_SYS_OCM_DATA_ADDR       0xF8000000
 #define CONFIG_SYS_OCM_DATA_SIZE       0x1000
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_OCM_DATA_ADDR /* inside of OCM               */
-#define CONFIG_SYS_INIT_RAM_END        CONFIG_SYS_OCM_DATA_SIZE /* End of used area in RAM     */
+#define CONFIG_SYS_INIT_RAM_SIZE       CONFIG_SYS_OCM_DATA_SIZE /* Size of used area in RAM    */
 
 #define CONFIG_SYS_GBL_DATA_SIZE       128  /* size in bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - CONFIG_SYS_GBL_DATA_SIZE)
 /* reserve some memory for POST and BOOT limit info */
 #define CONFIG_SYS_INIT_SP_OFFSET      (CONFIG_SYS_GBL_DATA_OFFSET - 16)
 
@@ -302,14 +304,6 @@
 #define CONFIG_SYS_TIME_POST           5000
 #define CONFIG_SYS_TIME_FACTORY_RESET  10000
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD          0x01            /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM          0x02            /* Software reboot                      */
-
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400          /* speed to run kgdb serial port */
 #define CONFIG_KGDB_SER_INDEX  2               /* which serial port to use */