[PATCH] Update AMCC Yucca 440SPe eval board support

[platform/kernel/u-boot.git] / include / configs / yucca.h

diff --git a/include/configs/yucca.h b/include/configs/yucca.h
index a6532b5..eb4859c 100644 (file)
--- a/include/configs/yucca.h
+++ b/include/configs/yucca.h
@@ -45,11 +45,11 @@
 #define EXTCLK_50              50000000
 #define EXTCLK_83              83333333
 
-#define        CONFIG_IBM_EMAC4_V4             1
-#define        CONFIG_MISC_INIT_F              1       /* Use misc_init_f()    */
+#define        CONFIG_MISC_INIT_F      1       /* Use misc_init_f()            */
+#define CONFIG_ADD_RAM_INFO    1       /* Print additional info        */
 #undef  CONFIG_SHOW_BOOT_PROGRESS
 #undef  CONFIG_STRESS
-#undef  ENABLE_ECC
+
 /*-----------------------------------------------------------------------
  * Base addresses -- Note these are effective addresses where the
  * actual resources get mapped (not physical addresses)
@@ -118,10 +118,9 @@
 /*-----------------------------------------------------------------------
  * DDR SDRAM
  *----------------------------------------------------------------------*/
-#undef CONFIG_SPD_EEPROM               /* Use SPD EEPROM for setup     */
-#define SPD_EEPROM_ADDRESS {0x53, 0x52}        /* SPD i2c spd addresses        */
-#define IIC0_DIMM0_ADDR                0x53
-#define IIC0_DIMM1_ADDR                0x52
+#define CONFIG_SPD_EEPROM      1       /* Use SPD EEPROM for setup     */
+#define SPD_EEPROM_ADDRESS     {0x53, 0x52}    /* SPD i2c spd addresses*/
+#undef CONFIG_DDR_ECC                  /* no ECC support for now       */
 
 /*-----------------------------------------------------------------------
  * I2C
@@ -178,6 +177,7 @@
        "bootfile=yucca/uImage\0"                                       \
        "kernel_addr=E7F10000\0"                                        \
        "ramdisk_addr=E7F20000\0"                                       \
+       "initrd_high=30000000\0"                                        \
        "load=tftp 100000 yuca/u-boot.bin\0"                            \
        "update=protect off 2:4-7;era 2:4-7;"                           \
                "cp.b ${fileaddr} FFFB0000 ${filesize};"                \
@@ -210,6 +210,7 @@
 /* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
 #include <cmd_confdefs.h>
 
+#define        CONFIG_IBM_EMAC4_V4     1
 #define CONFIG_MII             1       /* MII PHY management           */
 #undef CONFIG_NET_MULTI
 #define CONFIG_PHY_ADDR                1       /* PHY address, See schematics  */