# define CONFIG_SYS_MONITOR_LEN 0x00040000 /* 256KB */
#endif
-#define CONFIG_SYS_MALLOC_LEN (256 << 10) /* heap 256KB */
-
/* Linux boot param area in RAM (used only when booting linux) */
#define CONFIG_SYS_BOOTPARAMS_LEN (64 << 10)
/* Memory test is destructive so default must not overlap vectors or U-Boot*/
-#define CONFIG_SYS_MEMTEST_START MEMADDR(0x01000000)
-#define CONFIG_SYS_MEMTEST_END MEMADDR(0x02000000)
/* Load address for stand-alone applications.
* MEMADDR cannot be used here, because the definition needs to be
#define XTENSA_SYS_TEXT_ADDR \
(MEMADDR(CONFIG_SYS_MEMORY_SIZE) - CONFIG_SYS_MONITOR_LEN)
-/* Used by tftpboot; env var 'loadaddr' */
-#define CONFIG_SYS_LOAD_ADDR MEMADDR(0x02000000)
-
/*==============================*/
/* U-Boot general configuration */
/*==============================*/
/* U-Boot autoboot configuration */
/*==============================*/
-#define CONFIG_MX_CYCLIC
-
/*=========================================*/
/* FPGA Registers (board info and control) */
/* Input clk to NS16550 (in Hz; the SYS_CLK_FREQ is in kHz) */
#define CONFIG_SYS_NS16550_CLK CONFIG_SYS_CLK_FREQ
-#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
/*======================*/
/* Ethernet Driver Info */
* Put environment in top block (64kB)
* Another option would be to put env. in 2nd param block offs 8KB, size 8KB
*/
-#define CONFIG_ENV_OFFSET (CONFIG_SYS_FLASH_SIZE - CONFIG_SYS_FLASH_SECT_SZ)
-#define CONFIG_ENV_SIZE CONFIG_SYS_FLASH_SECT_SZ
/* print 'E' for empty sector on flinfo */
#define CONFIG_SYS_FLASH_EMPTY_INFO