#define CONFIG_DOS_PARTITION 1
#define BOARD_LATE_INIT 1
#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
-#define CONFIG_SYS_HZ 3686400 /* incrementer freq: 3.6864 MHz */
+/* we will never enable dcache, because we have to setup MMU first */
+#define CONFIG_SYS_NO_DCACHE
-#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
-#define CONFIG_SYS_HZ 3686400 /* incrementer freq: 3.6864 MHz */
+#define CONFIG_SYS_HZ 1000
#define CONFIG_SYS_CPUSPEED 0x161 /* set core clock to 400/200/100 MHz */
#define CONFIG_NR_DRAM_BANKS 1 /* we have 1 bank of DRAM */
* JFFS2 partitions
*/
/* No command line, one static partition, whole device */
-#undef CONFIG_JFFS2_CMDLINE
+#undef CONFIG_CMD_MTDPARTS
#define CONFIG_JFFS2_DEV "nor0"
#define CONFIG_JFFS2_PART_SIZE 0xFFFFFFFF
#define CONFIG_JFFS2_PART_OFFSET 0x00000000
/* mtdparts command line support */
/* Note: fake mtd_id used, no linux mtd map file */
/*
-#define CONFIG_JFFS2_CMDLINE
+#define CONFIG_CMD_MTDPARTS
#define MTDIDS_DEFAULT "nor0=xsengine-0"
#define MTDPARTS_DEFAULT "mtdparts=xsengine-0:256k(uboot),1m(kernel1),8m(kernel2)"
*/
#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
/* Hardware drivers */
-#define CONFIG_DRIVER_SMC91111
+#define CONFIG_NET_MULTI
+#define CONFIG_SMC91111
#define CONFIG_SMC91111_BASE 0x04000300
#define CONFIG_SMC_USE_32_BIT 1
/* select serial console configuration */
+#define CONFIG_PXA_SERIAL
#define CONFIG_FFUART 1
/* allow to overwrite serial and ethaddr */
*/
#include <config_cmd_default.h>
-#define CONFIG_CMD_MMC
#define CONFIG_CMD_FAT
#define CONFIG_CMD_PING
#define CONFIG_CMD_JFFS2
#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
#define CONFIG_SYS_MEMTEST_START 0xA0400000 /* memtest works on */
#define CONFIG_SYS_MEMTEST_END 0xA0800000 /* 4 ... 8 MB in DRAM */
-#undef CONFIG_SYS_CLKS_IN_HZ /* everything, incl board info, in Hz */
#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } /* valid baudrates */
-#define CONFIG_SYS_MMC_BASE 0xF0000000
#define CONFIG_SYS_LOAD_ADDR 0xA0000000 /* load kernel to this address */
+#ifdef CONFIG_MMC
+#define CONFIG_PXA_MMC
+#define CONFIG_CMD_MMC
+#define CONFIG_SYS_MMC_BASE 0xF0000000
+#endif
+
/* Stack sizes - The stack sizes are set up in start.S using the settings below */
#define CONFIG_STACKSIZE (128*1024) /* regular stack */
#ifdef CONFIG_USE_IRQ