cmd: add Kconfig option for 'date' command

[platform/kernel/u-boot.git] / include / configs / xpedite517x.h

diff --git a/include/configs/xpedite517x.h b/include/configs/xpedite517x.h
index 6d95789..447fd95 100644 (file)
--- a/include/configs/xpedite517x.h
+++ b/include/configs/xpedite517x.h
@@ -31,19 +31,16 @@
 #define CONFIG_FSL_PCI_INIT    1       /* Use common FSL init code */
 #define CONFIG_PCI_INDIRECT_BRIDGE 1   /* indirect PCI bridge support */
 #define CONFIG_SYS_PCI_64BIT   1       /* enable 64-bit PCI resources */
-#define CONFIG_FSL_LAW         1       /* Use common FSL init code */
 
 /*
  * DDR config
  */
-#define CONFIG_SYS_FSL_DDR2
 #define CONFIG_SPD_EEPROM              /* Use SPD EEPROM for DDR setup */
 #define CONFIG_DDR_SPD
 #define CONFIG_MEM_INIT_VALUE          0xdeadbeef
 #define SPD_EEPROM_ADDRESS1            0x54    /* Both channels use the */
 #define SPD_EEPROM_ADDRESS2            0x54    /* same SPD data         */
 #define SPD_EEPROM_OFFSET              0x200   /* OFFSET of SPD in EEPROM */
-#define CONFIG_NUM_DDR_CONTROLLERS     2
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   1
 #define CONFIG_DDR_ECC
@@ -76,7 +73,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  * Base addresses -- Note these are effective addresses where the
  * actual resources get mapped (not physical addresses)
  */
-#define CONFIG_SYS_CCSRBAR_DEFAULT     0xff700000      /* CCSRBAR Default */
 #define CONFIG_SYS_CCSRBAR             0xef000000      /* relocated CCSRBAR */
 #define CONFIG_SYS_CCSRBAR_PHYS                CONFIG_SYS_CCSRBAR
 #define CONFIG_SYS_CCSRBAR_PHYS_LOW    CONFIG_SYS_CCSRBAR
@@ -217,7 +213,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_NS16550_COM2        (CONFIG_SYS_CCSRBAR+0x4600)
 #define CONFIG_SYS_BAUDRATE_TABLE      \
        {300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 115200}
-#define CONFIG_BAUDRATE                        115200
 #define CONFIG_LOADS_ECHO              1       /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change */
 
@@ -507,7 +502,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 /*
  * Command configuration.
  */
-#define CONFIG_CMD_DATE
 #define CONFIG_CMD_DS4510
 #define CONFIG_CMD_DS4510_INFO
 #define CONFIG_CMD_DTT