#define CONFIG_PXA250 1 /* This is an PXA250 CPU */
#define CONFIG_XM250 1 /* on a MicroSys XM250 Board */
#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
+#define CONFIG_SYS_TEXT_BASE 0x0
/* we will never enable dcache, because we have to setup MMU first */
#define CONFIG_SYS_NO_DCACHE
*
*/
#define CONFIG_SYS_MALLOC_LEN (256*1024)
-#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
/*
* Hardware drivers
*/
-#define CONFIG_DRIVER_SMC91111
+#define CONFIG_NET_MULTI
+#define CONFIG_SMC91111
#define CONFIG_SMC91111_BASE 0x04000300
#undef CONFIG_SMC91111_EXT_PHY
#define CONFIG_SMC_USE_32_BIT
/*
* I2C bus
*/
+#define CONFIG_I2C_MV 1
+#define CONFIG_MV_I2C_REG 0x40301680
#define CONFIG_HARD_I2C 1
#define CONFIG_SYS_I2C_SPEED 50000
#define CONFIG_SYS_I2C_SLAVE 0xfe
/*
* select serial console configuration
*/
+#define CONFIG_PXA_SERIAL
#define CONFIG_FFUART 1 /* we use FFUART */
/* allow to overwrite serial and ethaddr */
#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1
+#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1
+#define CONFIG_SYS_INIT_SP_ADDR (GENERATED_GBL_DATA_SIZE + PHYS_SDRAM_1)
+
/*
* FLASH and environment organization
*/
* Clocks, power control and interrupts
*/
#define CONFIG_SYS_PSSR_VAL 0x00000030
-#define CONFIG_SYS_CCCR_VAL 0x00000161 /* 100 MHz memory, 400 MHz CPU, 400 Turbo */
-#define CONFIG_SYS_CKEN_VAL 0x000141ec /* FFUART and STUART enabled */
-#define CONFIG_SYS_ICMR_VAL 0x00000000 /* No interrupts enabled */
+#define CONFIG_SYS_CCCR 0x00000161 /* 100 MHz memory, 400 MHz CPU, 400 Turbo */
+#define CONFIG_SYS_CKEN 0x000141ec /* FFUART and STUART enabled */
+#define CONFIG_SYS_ICMR 0x00000000 /* No interrupts enabled */
/* FIXME
*
#define CONFIG_SYS_MDCNFG_VAL 0x000009c9
#define CONFIG_SYS_MDMRS_VAL 0x00220022
#define CONFIG_SYS_MDREFR_VAL 0x000da018 /* Initial setting, individual bits set in lowlevel_init.S */
+#define CONFIG_SYS_FLYCNFG_VAL 0x00000000
+#define CONFIG_SYS_SXCNFG_VAL 0x00000000
/*
* PCMCIA and CF Interfaces (NOT USED, these values from lubbock init)