configs: Migrate RBTREE, LZO, CMD_MTDPARTS, CMD_UBI and CMD_UBIFS

[platform/kernel/u-boot.git] / include / configs / woodburn_common.h

diff --git a/include/configs/woodburn_common.h b/include/configs/woodburn_common.h
index de6b183..68a9db5 100644 (file)
--- a/include/configs/woodburn_common.h
+++ b/include/configs/woodburn_common.h
@@ -20,13 +20,6 @@
 
 #define CONFIG_SYS_DCACHE_OFF
 
-#define CONFIG_DISPLAY_CPUINFO
-
-/* Only in case the value is not present in mach-types.h */
-#ifndef MACH_TYPE_FLEA3
-#define MACH_TYPE_FLEA3                3668
-#endif
-
 #define CONFIG_MACH_TYPE               MACH_TYPE_FLEA3
 
 /* This is required to setup the ESDC controller */
@@ -62,8 +55,6 @@
 #define CONFIG_RTC_MC13XXX
 
 /* mmc driver */
-#define CONFIG_MMC
-#define CONFIG_GENERIC_MMC
 #define CONFIG_FSL_ESDHC
 #define CONFIG_SYS_FSL_ESDHC_ADDR      0
 #define CONFIG_SYS_FSL_ESDHC_NUM       1
@@ -77,21 +68,16 @@
 /* allow to overwrite serial and ethaddr */
 #define CONFIG_ENV_OVERWRITE
 #define CONFIG_CONS_INDEX      1
-#define CONFIG_BAUDRATE                115200
 
 /*
  * Command definition
  */
-#define CONFIG_CMD_DATE
 #define CONFIG_BOOTP_SUBNETMASK
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_DNS
 
 #define CONFIG_CMD_NAND
 
-#define CONFIG_DOS_PARTITION
-#define CONFIG_EFI_PARTITION
-
 #define CONFIG_MXC_GPIO
 
 #define CONFIG_NET_RETRY_COUNT 100
@@ -132,13 +118,6 @@
 #define CONFIG_SYS_LOAD_ADDR           CONFIG_LOADADDR
 
 /*
- * Stack sizes
- *
- * The stack sizes are set up in start.S using the settings below
- */
-#define CONFIG_STACKSIZE       (128 * 1024)    /* regular stack */
-
-/*
  * Physical Memory Map
  */
 #define CONFIG_NR_DRAM_BANKS   1
@@ -156,7 +135,6 @@
 /*
  * MTD Command for mtdparts
  */
-#define CONFIG_CMD_MTDPARTS
 #define CONFIG_MTD_DEVICE
 #define CONFIG_FLASH_CFI_MTD
 #define CONFIG_MTD_PARTITIONS