+/* SPDX-License-Identifier: GPL-2.0+ */
/*
* include/configs/ulcb.h
* This file is ULCB board configuration.
*
* Copyright (C) 2017 Renesas Electronics Corporation
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __ULCB_H
#define __ULCB_H
-#undef DEBUG
-
#include "rcar-gen3-common.h"
/* Ethernet RAVB */
-#define CONFIG_BITBANGMII
#define CONFIG_BITBANGMII_MULTI
-/* Board Clock */
-/* XTAL_CLK : 33.33MHz */
-#define CONFIG_SYS_CLK_FREQ 33333333u
-
/* Generic Timer Definitions (use in assembler source) */
#define COUNTER_FREQUENCY 0xFE502A /* 16.66MHz from CPclk */
-/* CPLD SPI */
-#define CONFIG_CMD_SPI
-#define CONFIG_SOFT_SPI
-#define SPI_DELAY udelay(0)
-#define SPI_SDA(val) ulcb_softspi_sda(val)
-#define SPI_SCL(val) ulcb_softspi_scl(val)
-#define SPI_READ ulcb_softspi_read()
-#ifndef __ASSEMBLY__
-void ulcb_softspi_sda(int);
-void ulcb_softspi_scl(int);
-unsigned char ulcb_softspi_read(void);
-#endif
-
-/* i2c */
-#define CONFIG_SYS_I2C
-#define CONFIG_SYS_I2C_SH
-#define CONFIG_SYS_I2C_SLAVE 0x60
-#define CONFIG_SYS_I2C_SH_NUM_CONTROLLERS 1
-#define CONFIG_SYS_I2C_SH_SPEED0 400000
-#define CONFIG_SH_I2C_DATA_HIGH 4
-#define CONFIG_SH_I2C_DATA_LOW 5
-#define CONFIG_SH_I2C_CLOCK 10000000
-
-#define CONFIG_SYS_I2C_POWERIC_ADDR 0x30
-
/* Environment in eMMC, at the end of 2nd "boot sector" */
-#define CONFIG_ENV_OFFSET (-CONFIG_ENV_SIZE)
-#define CONFIG_SYS_MMC_ENV_DEV 1
-#define CONFIG_SYS_MMC_ENV_PART 2
+
+#define CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS
+#define CONFIG_FLASH_SHOW_PROGRESS 45
+#define CONFIG_SYS_FLASH_QUIET_TEST
+#define CONFIG_SYS_FLASH_BANKS_LIST { 0x08000000 }
+#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT
+#define CONFIG_SYS_MAX_FLASH_SECT 256
+#define CONFIG_SYS_WRITE_SWAPPED_DATA
#endif /* __ULCB_H */