/*
- * (C) Copyright 2002-2003
+ * (C) Copyright 2002-2005
* Gary Jennejohn <gj@denx.de>
*
* Configuation settings for the TRAB board.
#ifndef __CONFIG_H
#define __CONFIG_H
-#ifdef CONFIG_OLD_VERSION /* Old configuration: */
-#define CONFIG_RAM_16MB /* 16 MB SDRAM */
-#endif
-#define CONFIG_FLASH_8MB /* 8 MB Flash */
-
/*
- * If we are developing, we might want to start armboot from ram
- * so we MUST NOT initialize critical regs like mem-timing ...
+ * Default configuration is with 8 MB Flash, 32 MB RAM
*/
-#define CONFIG_INIT_CRITICAL /* undef for developing */
+#if (!defined(CONFIG_FLASH_8MB)) && (!defined(CONFIG_FLASH_16MB))
+# define CONFIG_FLASH_8MB /* 8 MB Flash */
+#endif
+#if (!defined(CONFIG_RAM_16MB)) && (!defined(CONFIG_RAM_32MB))
+# define CONFIG_RAM_32MB /* 32 MB SDRAM */
+#endif
/*
* High Level Configuration Options
* address 0x54 with 8bit addressing
***********************************************************/
#define CONFIG_HARD_I2C /* I2C with hardware support */
-#define CFG_I2C_SPEED 100000 /* I2C speed */
-#define CFG_I2C_SLAVE 0x7F /* I2C slave addr */
+#define CFG_I2C_SPEED 100000 /* I2C speed */
+#define CFG_I2C_SLAVE 0x7F /* I2C slave addr */
#define CFG_I2C_EEPROM_ADDR 0x54 /* EEPROM address */
#define CFG_I2C_EEPROM_ADDR_LEN 1 /* 1 address byte */
#define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10
/* USB stuff */
-#define CONFIG_USB_OHCI 1
+#define CONFIG_USB_OHCI_NEW 1
#define CONFIG_USB_STORAGE 1
#define CONFIG_DOS_PARTITION 1
+#undef CFG_USB_OHCI_BOARD_INIT
+#define CFG_USB_OHCI_CPU_INIT 1
+
+#define CFG_USB_OHCI_REGS_BASE 0x14200000
+#define CFG_USB_OHCI_SLOT_NAME "s3c2400"
+#define CFG_USB_OHCI_MAX_ROOT_PORTS 15
+
/*
* Size of malloc() pool
*/
/* Use s3c2400's RTC */
#define CONFIG_RTC_S3C24X0 1
+
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_BSP
+#define CONFIG_CMD_DATE
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_FAT
+#define CONFIG_CMD_NFS
+#define CONFIG_CMD_SNTP
+#define CONFIG_CMD_USB
+
#ifdef CONFIG_HWFLOW
-#define CONFIG_COMMANDS_ADD_HWFLOW CFG_CMD_HWFLOW
-#else
-#define CONFIG_COMMANDS_ADD_HWFLOW 0
+ #define CONFIG_CMD_HWFLOW
#endif
#ifdef CONFIG_VFD
-#define CONFIG_COMMANDS_ADD_VFD CFG_CMD_VFD
-#else
-#define CONFIG_COMMANDS_ADD_VFD 0
+ #define CONFIG_CMD_VFD
#endif
#ifdef CONFIG_DRIVER_S3C24X0_I2C
-#define CONFIG_COMMANDS_ADD_EEPROM CFG_CMD_EEPROM
-#define CONFIG_COMMANDS_I2C CFG_CMD_I2C
-#else
-#define CONFIG_COMMANDS_ADD_EEPROM 0
-#define CONFIG_COMMANDS_I2C 0
+ #define CONFIG_CMD_EEPROM
+ #define CONFIG_CMD_I2C
#endif
#ifndef USE_920T_MMU
-#define CONFIG_COMMANDS ((CONFIG_CMD_DFL & ~CFG_CMD_CACHE) | \
- CFG_CMD_BSP | \
- CFG_CMD_DATE | \
- CONFIG_COMMANDS_ADD_HWFLOW | \
- CONFIG_COMMANDS_ADD_VFD | \
- CONFIG_COMMANDS_ADD_EEPROM | \
- CFG_CMD_USB | \
- CFG_CMD_FAT | \
- CONFIG_COMMANDS_I2C )
-#else
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | \
- CFG_CMD_BSP | \
- CFG_CMD_DATE | \
- CONFIG_COMMANDS_ADD_HWFLOW | \
- CONFIG_COMMANDS_ADD_VFD | \
- CONFIG_COMMANDS_ADD_EEPROM | \
- CFG_CMD_USB | \
- CFG_CMD_FAT | \
- CONFIG_COMMANDS_I2C )
+ #undef CONFIG_CMD_CACHE
#endif
+
/* moved up */
#define CFG_HUSH_PARSER 1 /* use "hush" command parser */
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
-
#define CONFIG_BOOTDELAY 5
#define CONFIG_ZERO_BOOTDELAY_CHECK /* allow to break in always */
#define CONFIG_PREBOOT "echo;echo *** booting ***;echo"
#else /* !CFG_HUSH_PARSER */
#define CONFIG_EXTRA_ENV_SETTINGS \
"nfs_args=setenv bootargs root=/dev/nfs rw " \
- "nfsroot=$(serverip):$(rootpath)\0" \
+ "nfsroot=${serverip}:${rootpath}\0" \
"rootpath=/opt/eldk/arm_920TDI\0" \
"ram_args=setenv bootargs root=/dev/ram rw\0" \
- "add_net=setenv bootargs $(bootargs) ethaddr=$(ethaddr) " \
- "ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname)::off\0" \
- "add_misc=setenv bootargs $(bootargs) console=ttyS0 panic=1\0" \
+ "add_net=setenv bootargs ${bootargs} ethaddr=${ethaddr} " \
+ "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:${hostname}::off\0" \
+ "add_misc=setenv bootargs ${bootargs} console=ttyS0 panic=1\0" \
"u-boot=/tftpboot/TRAB/u-boot.bin\0" \
- "load=tftp C100000 $(u-boot)\0" \
+ "load=tftp C100000 ${u-boot}\0" \
"update=protect off 0 5FFFF;era 0 5FFFF;" \
- "cp.b C100000 0 $(filesize)\0" \
+ "cp.b C100000 0 ${filesize}\0" \
"loadfile=/tftpboot/TRAB/uImage\0" \
"loadaddr=c400000\0" \
- "net_load=tftpboot $(loadaddr) $(loadfile)\0" \
+ "net_load=tftpboot ${loadaddr} ${loadfile}\0" \
"net_nfs=run net_load nfs_args add_net add_misc;bootm\0" \
"kernel_addr=000C0000\0" \
- "flash_nfs=run nfs_args add_net add_misc;bootm $(kernel_addr)\0" \
+ "flash_nfs=run nfs_args add_net add_misc;bootm ${kernel_addr}\0" \
"mdm_init1=ATZ\0" \
"mdm_init2=ATS0=1\0" \
"mdm_flow_control=rts/cts\0"
#endif /* CFG_HUSH_PARSER */
-#else /* CONFIG_FLASH_8MB => 8 MB flash */
+#else /* CONFIG_FLASH_8MB => 8 MB flash */
#ifdef CFG_HUSH_PARSER
#define CONFIG_EXTRA_ENV_SETTINGS \
"nfs_args=setenv bootargs root=/dev/nfs rw " \
"add_net=setenv bootargs $bootargs ethaddr=$ethaddr " \
"ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname::off\0" \
"add_misc=setenv bootargs $bootargs console=ttyS0 panic=1\0" \
- "u-boot=/tftpboot/TRAB/u-boot.bin-old\0" \
+ "u-boot=/tftpboot/TRAB/u-boot.bin\0" \
"load=tftp C100000 ${u-boot}\0" \
"update=protect off 0 3FFFF;era 0 3FFFF;" \
"cp.b C100000 0 $filesize;" \
#else /* !CFG_HUSH_PARSER */
#define CONFIG_EXTRA_ENV_SETTINGS \
"nfs_args=setenv bootargs root=/dev/nfs rw " \
- "nfsroot=$(serverip):$(rootpath)\0" \
+ "nfsroot=${serverip}:${rootpath}\0" \
"rootpath=/opt/eldk/arm_920TDI\0" \
"ram_args=setenv bootargs root=/dev/ram rw\0" \
- "add_net=setenv bootargs $(bootargs) ethaddr=$(ethaddr) " \
- "ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname)::off\0" \
- "add_misc=setenv bootargs $(bootargs) console=ttyS0 panic=1\0" \
- "u-boot=/tftpboot/TRAB/u-boot.bin-old\0" \
- "load=tftp C100000 $(u-boot)\0" \
+ "add_net=setenv bootargs ${bootargs} ethaddr=${ethaddr} " \
+ "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:${hostname}::off\0" \
+ "add_misc=setenv bootargs ${bootargs} console=ttyS0 panic=1\0" \
+ "u-boot=/tftpboot/TRAB/u-boot.bin\0" \
+ "load=tftp C100000 ${u-boot}\0" \
"update=protect off 0 3FFFF;era 0 3FFFF;" \
- "cp.b C100000 0 $(filesize);" \
+ "cp.b C100000 0 ${filesize};" \
"setenv filesize;saveenv\0" \
"loadfile=/tftpboot/TRAB/uImage\0" \
"loadaddr=C400000\0" \
- "net_load=tftpboot $(loadaddr) $(loadfile)\0" \
+ "net_load=tftpboot ${loadaddr} ${loadfile}\0" \
"net_nfs=run net_load nfs_args add_net add_misc;bootm\0" \
"kernel_addr=000C0000\0" \
- "flash_nfs=run nfs_args add_net add_misc;bootm $(kernel_addr)\0" \
+ "flash_nfs=run nfs_args add_net add_misc;bootm ${kernel_addr}\0" \
"mdm_init1=ATZ\0" \
"mdm_init2=ATS0=1\0" \
"mdm_flow_control=rts/cts\0"
#endif /* CFG_HUSH_PARSER */
#endif /* CONFIG_FLASH_8MB */
-#if 0 /* disabled for development */
+#if 1 /* feel free to disable for development */
#define CONFIG_AUTOBOOT_KEYED /* Enable password protection */
-#define CONFIG_AUTOBOOT_PROMPT "\nEnter password - autoboot in %d sec...\n"
-#define CONFIG_AUTOBOOT_DELAY_STR "system" /* 1st password */
+#define CONFIG_AUTOBOOT_PROMPT \
+ "\nEnter password - autoboot in %d sec...\n", bootdelay
+#define CONFIG_AUTOBOOT_DELAY_STR "R" /* 1st "password" */
#endif
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CONFIG_KGDB_BAUDRATE 115200 /* speed to run kgdb serial port */
/* what's this ? it's not used anywhere */
#define CONFIG_KGDB_SER_INDEX 1 /* which serial port to use */
#define CFG_MONITOR_BASE CFG_FLASH_BASE
#define CFG_MONITOR_LEN (256 << 10)
+/* Dynamic MTD partition support */
+#define CONFIG_JFFS2_CMDLINE
+#define MTDIDS_DEFAULT "nor0=0"
+
+/* production flash layout */
+#define MTDPARTS_DEFAULT "mtdparts=0:16k(Firmware1)ro," \
+ "16k(Env1)," \
+ "16k(Env2)," \
+ "336k(Firmware2)ro," \
+ "896k(Kernel)," \
+ "5376k(Root-FS)," \
+ "1408k(JFFS2)," \
+ "-(VFD)"
+
/*-----------------------------------------------------------------------
* FLASH and environment organization
*/
#endif
/* timeout values are in ticks */
-#define CFG_FLASH_ERASE_TOUT (2*CFG_HZ) /* Timeout for Flash Erase */
+#define CFG_FLASH_ERASE_TOUT (15*CFG_HZ) /* Timeout for Flash Erase */
#define CFG_FLASH_WRITE_TOUT (2*CFG_HZ) /* Timeout for Flash Write */
#define CFG_ENV_IS_IN_FLASH 1
#define CFG_ENV_OFFSET_REDUND (CFG_ENV_ADDR+CFG_ENV_SECT_SIZE)
#define CFG_ENV_SIZE_REDUND (CFG_ENV_SIZE)
+#define CFG_USE_PPCENV /* Environment embedded in sect .ppcenv */
+
/* Initial value of the on-board touch screen brightness */
#define CFG_BRIGHTNESS 0x20
projects / platform / kernel / u-boot.git / blobdiff