/* Fixup settings */
-/* SPL settings */
-#undef CONFIG_SPL_ETH_SUPPORT
-#undef CONFIG_SPL_MAX_FOOTPRINT
-#define CONFIG_SPL_MAX_FOOTPRINT CONFIG_SYS_SPI_U_BOOT_OFFS
-#define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot.img"
-
-/* No falcon support */
-#undef CONFIG_SPL_OS_BOOT
-
-/* FPGA commands that we don't use */
-
-/* Extras */
-
-/* Faster flash, ours may run at 108 MHz */
-#undef CONFIG_SPI_FLASH_WINBOND
-
/* Setup proper boot sequences for Miami boards */
-#if defined(CONFIG_USB)
+#if defined(CONFIG_USB_HOST)
# define EXTRA_ENV_USB \
"usbreset=i2c dev 1 && i2c mw 41 1 ff && i2c mw 41 3 fe && "\
"i2c mw 41 1 fe && i2c mw 41 1 ff\0" \
"${devicetree_addr}; " \
"fi\0"
/* Note that addresses here should match the addresses in the env */
-# undef DFU_ALT_INFO
# define DFU_ALT_INFO \
"dfu_alt_info=" \
"uImage ram 0x2080000 0x500000;" \
EXTRA_ENV_USB \
DFU_ALT_INFO
-#undef CONFIG_BOOTCOMMAND
-#define CONFIG_BOOTCOMMAND "if mmcinfo; then " \
- "if fatload mmc 0 0x1900000 ${bootscript}; then source 0x1900000; " \
- "fi; fi; run $modeboot"
-#undef CONFIG_DISPLAY_BOARDINFO
-
#endif /* __CONFIG_TOPIC_MIAMI_H */