+/* SPDX-License-Identifier: GPL-2.0+ */
/*
* (C) Copyright 2014 Topic Embedded Products
*
* Configuration for Zynq Evaluation and Development Board - Miami
* See zynq-common.h for Zynq common configs
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __CONFIG_TOPIC_MIAMI_H
#define __CONFIG_TOPIC_MIAMI_H
-#define CONFIG_ZYNQ_I2C0
-#define CONFIG_ZYNQ_I2C1
/* Speed up boot time by ignoring the environment which we never used */
-#define CONFIG_ENV_IS_NOWHERE
#include "zynq-common.h"
/* Fixup settings */
-#undef CONFIG_ENV_SIZE
-#define CONFIG_ENV_SIZE 0x8000
-#undef CONFIG_ENV_OFFSET
-#define CONFIG_ENV_OFFSET 0x80000
/* SPL settings */
#undef CONFIG_SPL_ETH_SUPPORT
-#undef CONFIG_SYS_SPI_U_BOOT_OFFS
-#define CONFIG_SYS_SPI_U_BOOT_OFFS 0x20000
#undef CONFIG_SPL_MAX_FOOTPRINT
#define CONFIG_SPL_MAX_FOOTPRINT CONFIG_SYS_SPI_U_BOOT_OFFS
#define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot.img"
/* FPGA commands that we don't use */
/* Extras */
-#define CONFIG_CMD_MEMTEST
#undef CONFIG_SYS_MEMTEST_START
#define CONFIG_SYS_MEMTEST_START 0
#undef CONFIG_SYS_MEMTEST_END
#define CONFIG_SYS_MEMTEST_END 0x18000000
/* Faster flash, ours may run at 108 MHz */
-#undef CONFIG_SF_DEFAULT_SPEED
-#define CONFIG_SF_DEFAULT_SPEED 108000000
-#define CONFIG_SF_DEFAULT_MODE SPI_MODE_0
-#undef CONFIG_SF_DUAL_FLASH
-#define CONFIG_ENV_SPI_MAX_HZ CONFIG_SF_DEFAULT_SPEED
#undef CONFIG_SPI_FLASH_WINBOND
-#undef CONFIG_SPI_FLASH_ISSI
/* Setup proper boot sequences for Miami boards */
# define EXTRA_ENV_USB
#endif
-#undef CONFIG_PREBOOT
-
#undef CONFIG_EXTRA_ENV_SETTINGS
#define CONFIG_EXTRA_ENV_SETTINGS \
"kernel_image=uImage\0" \
"fi; fi; run $modeboot"
#undef CONFIG_DISPLAY_BOARDINFO
-/* Further tweaks to reduce image size */
-#undef CONFIG_CMD_BOOTZ
-#undef CONFIG_CMD_NET
-
#endif /* __CONFIG_TOPIC_MIAMI_H */