Rename CONFIG_EHCI_IS_TDI to CONFIG_USB_EHCI_IS_TDI

[platform/kernel/u-boot.git] / include / configs / topic_miami.h

diff --git a/include/configs/topic_miami.h b/include/configs/topic_miami.h
index 73fdfae..18179e9 100644 (file)
--- a/include/configs/topic_miami.h
+++ b/include/configs/topic_miami.h
@@ -17,36 +17,24 @@
 /* Fixup settings */
 
 /* SPL settings */
-#undef CONFIG_SPL_ETH_SUPPORT
+#undef CONFIG_SPL_ETH
 #undef CONFIG_SPL_MAX_FOOTPRINT
 #define CONFIG_SPL_MAX_FOOTPRINT       CONFIG_SYS_SPI_U_BOOT_OFFS
 #define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME     "u-boot.img"
 
-/* sspi command isn't useful */
-#undef CONFIG_CMD_SPI
-
-/* No useful gpio */
-#undef CONFIG_ZYNQ_GPIO
-#undef CONFIG_CMD_GPIO
-
 /* No falcon support */
 #undef CONFIG_SPL_OS_BOOT
-#undef CONFIG_SPL_FPGA_SUPPORT
 
 /* FPGA commands that we don't use */
 
 /* Extras */
-#undef CONFIG_SYS_MEMTEST_START
-#define CONFIG_SYS_MEMTEST_START       0
-#undef CONFIG_SYS_MEMTEST_END
-#define CONFIG_SYS_MEMTEST_END 0x18000000
 
 /* Faster flash, ours may run at 108 MHz */
 #undef CONFIG_SPI_FLASH_WINBOND
 
 /* Setup proper boot sequences for Miami boards */
 
-#if defined(CONFIG_USB)
+#if defined(CONFIG_USB_HOST)
 # define EXTRA_ENV_USB \
        "usbreset=i2c dev 1 && i2c mw 41 1 ff && i2c mw 41 3 fe && "\
                "i2c mw 41 1 fe && i2c mw 41 1 ff\0" \
@@ -61,7 +49,6 @@
                        "${devicetree_addr}; " \
        "fi\0"
   /* Note that addresses here should match the addresses in the env */
-# undef DFU_ALT_INFO
 # define DFU_ALT_INFO \
        "dfu_alt_info=" \
        "uImage ram 0x2080000 0x500000;" \