#endif
/* SPI Configuration */
-#define CONFIG_SPI_FLASH_STMICRO
#define CONFIG_DAVINCI_SPI
#define CONFIG_SYS_SPI_CLK clk_get_rate(KS2_CLK1_6)
#define CONFIG_SF_DEFAULT_SPEED 30000000
#define I2C_BUS_MAX 3
/* EEPROM definitions */
-#define CONFIG_SYS_I2C_MULTI_EEPROMS
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2
#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50
#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 6
/* EDMA3 */
#define CONFIG_TI_EDMA3
+#define DEFAULT_PMMC_BOOT_ENV \
+ "set_name_pmmc=setenv name_pmmc ti-sci-firmware-${soc_variant}.bin\0" \
+ "dev_pmmc=0\0" \
+ "get_pmmc_net=dhcp ${loadaddr} ${tftp_root}/${name_pmmc}\0" \
+ "get_pmmc_ramfs=run get_pmmc_net\0" \
+ "get_pmmc_mmc=load mmc ${bootpart} ${loadaddr} " \
+ "${bootdir}/${name_pmmc}\0" \
+ "get_pmmc_ubi=ubifsload ${loadaddr} ${bootdir}/${name_pmmc}\0" \
+ "run_pmmc=rproc init; rproc list; " \
+ "rproc load ${dev_pmmc} ${loadaddr} 0x${filesize}; " \
+ "rproc start ${dev_pmmc}\0" \
+
#define CONFIG_EXTRA_ENV_SETTINGS \
DEFAULT_LINUX_BOOT_ENV \
CONFIG_EXTRA_ENV_KS2_BOARD_SETTINGS \
"get_mon_net=dhcp ${addr_mon} ${tftp_root}/${name_mon}\0" \
"get_mon_ubi=ubifsload ${addr_mon} ${name_mon}\0" \
"get_uboot_net=dhcp ${loadaddr} ${tftp_root}/${name_uboot}\0" \
- "burn_uboot_spi=sf probe; sf erase 0 0x100000; " \
+ "burn_uboot_spi=sf probe; sf erase 0 0x80000; " \
"sf write ${loadaddr} 0 ${filesize}\0" \
"burn_uboot_nand=nand erase 0 0x100000; " \
"nand write ${loadaddr} 0 ${filesize}\0" \
"mtdparts=mtdparts=davinci_nand.0:" \
"1024k(bootloader)ro,512k(params)ro,-(ubifs)\0"
+#ifndef CONFIG_BOOTCOMMAND
#define CONFIG_BOOTCOMMAND \
"run init_${boot} get_fdt_${boot} get_mon_${boot} " \
"get_kern_${boot} run_mon run_kern"
+#endif
#define CONFIG_BOOTARGS \
-/* Linux interfacing */
-#define CONFIG_OF_BOARD_SETUP
-
/* Now for the remaining common defines */
#include <configs/ti_armv7_common.h>