#define CONFIG_BOOTDELAY 1
/*
- * DDR information. We say (for simplicity) that we have 1 bank,
- * always, even when we have more. We always start at 0x80000000,
- * and we place the initial stack pointer in our SRAM.
+ * DDR information. If the CONFIG_NR_DRAM_BANKS is not defined,
+ * we say (for simplicity) that we have 1 bank, always, even when
+ * we have more. We always start at 0x80000000, and we place the
+ * initial stack pointer in our SRAM. Otherwise, we can define
+ * CONFIG_NR_DRAM_BANKS before including this file.
*/
+#ifndef CONFIG_NR_DRAM_BANKS
#define CONFIG_NR_DRAM_BANKS 1
+#endif
#define CONFIG_SYS_SDRAM_BASE 0x80000000
#define CONFIG_SYS_INIT_SP_ADDR (NON_SECURE_SRAM_END - \
GENERATED_GBL_DATA_SIZE)
/* I2C IP block */
#define CONFIG_I2C
-#define CONFIG_HARD_I2C
-#define CONFIG_SYS_I2C_SPEED 100000
-#define CONFIG_SYS_I2C_SLAVE 1
-#define CONFIG_I2C_MULTI_BUS
-#define CONFIG_DRIVER_OMAP24XX_I2C
#define CONFIG_CMD_I2C
+#define CONFIG_SYS_I2C
+#define CONFIG_SYS_OMAP24_I2C_SPEED 100000
+#define CONFIG_SYS_OMAP24_I2C_SLAVE 1
+#define CONFIG_SYS_I2C_OMAP24XX
/* MMC/SD IP block */
#define CONFIG_MMC
#define CONFIG_SPL_FAT_LOAD_PAYLOAD_NAME "u-boot.img"
#ifdef CONFIG_SPL_OS_BOOT
-#define CONFIG_SYS_SPL_ARGS_ADDR (CONFIG_SYS_SDRAM_BASE + 0x100)
+#define CONFIG_SYS_SPL_ARGS_ADDR 0x80F80000
/* FAT */
#define CONFIG_SPL_FAT_LOAD_KERNEL_NAME "uImage"
#define CONFIG_SPL_BOARD_INIT
#ifdef CONFIG_NAND
-#define CONFIG_SPL_NAND_AM33XX_BCH /* OMAP4 and later ELM support */
#define CONFIG_SPL_NAND_SUPPORT
#define CONFIG_SPL_NAND_BASE
#define CONFIG_SPL_NAND_DRIVERS