Convert CONFIG_SPLASH_SCREEN et al to Kconfig

[platform/kernel/u-boot.git] / include / configs / ti_armv7_common.h

diff --git a/include/configs/ti_armv7_common.h b/include/configs/ti_armv7_common.h
index a1a053e..0c9856a 100644 (file)
--- a/include/configs/ti_armv7_common.h
+++ b/include/configs/ti_armv7_common.h
@@ -37,11 +37,18 @@
  * seen large trees).  We say all of this must be within the first 256MB
  * as that will normally be within the kernel lowmem and thus visible via
  * bootm_size and we only run on platforms with 256MB or more of memory.
+ *
+ * As a temporary storage for DTBO blobs (which should be applied into DTB
+ * blob), we use the location 15.5 MB above the ramdisk. If someone wants to
+ * use ramdisk bigger than 15.5 MB, then DTBO can be loaded and applied to DTB
+ * blob before loading the ramdisk, as DTBO location is only used as a temporary
+ * storage, and can be re-used after 'fdt apply' command is done.
  */
 #define DEFAULT_LINUX_BOOT_ENV \
        "loadaddr=0x82000000\0" \
        "kernel_addr_r=0x82000000\0" \
        "fdtaddr=0x88000000\0" \
+       "dtboaddr=0x89000000\0" \
        "fdt_addr_r=0x88000000\0" \
        "rdaddr=0x88080000\0" \
        "ramdisk_addr_r=0x88080000\0" \
@@ -56,7 +63,7 @@
        "name_fit=fitImage\0" \
        "update_to_fit=setenv loadaddr ${addr_fit}; setenv bootfile ${name_fit}\0" \
        "get_overlaystring=" \
-               "for overlay in $overlay_files;" \
+               "for overlay in $name_overlays;" \
                "do;" \
                "setenv overlaystring ${overlaystring}'#'${overlay};" \
                "done;\0" \
@@ -95,7 +102,6 @@
  * console baudrate of 115200 and use the default baud rate table.
  */
 #define CONFIG_SYS_MALLOC_LEN          SZ_32M
-#define CONFIG_ENV_OVERWRITE           /* Overwrite ethaddr / serial# */
 
 /* As stated above, the following choices are optional. */
 
@@ -155,7 +161,6 @@
 
 
 /* FAT sd card locations. */
-#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION     1
 #ifndef CONFIG_SPL_FS_LOAD_PAYLOAD_NAME
 #define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME        "u-boot.img"
 #endif
@@ -174,9 +179,6 @@
 /* General parts of the framework, required. */
 
 #ifdef CONFIG_MTD_RAW_NAND
-#define CONFIG_SPL_NAND_BASE
-#define CONFIG_SPL_NAND_DRIVERS
-#define CONFIG_SPL_NAND_ECC
 #define CONFIG_SYS_NAND_U_BOOT_START   CONFIG_SYS_TEXT_BASE
 #endif
 #endif /* !CONFIG_NOR_BOOT */