#include <asm/arch/base_addr_s10.h>
#include <asm/arch/handoff_s10.h>
+#include <linux/stringify.h>
/*
* U-Boot general configurations
/*
* U-Boot environment configurations
*/
-#define CONFIG_SYS_MMC_ENV_DEV 0 /* device 0 */
/*
* QSPI support
* CONFIG_BOOTARGS goes into the environment value "bootargs".
* Do note the value will override also the chosen node in FDT blob.
*/
-#define CONFIG_BOOTARGS "earlycon"
#define CONFIG_BOOTCOMMAND "run fatscript; run mmcload;run linux_qspi_enable;" \
"run mmcboot"
#define PHYS_SDRAM_1 0x0
#define PHYS_SDRAM_1_SIZE (1 * 1024 * 1024 * 1024)
#define CONFIG_SYS_SDRAM_BASE 0
-#define CONFIG_SYS_MEMTEST_START 0
-#define CONFIG_SYS_MEMTEST_END PHYS_SDRAM_1_SIZE - 0x200000
/*
* Serial / UART configurations
/*
* L4 Watchdog
*/
-#ifdef CONFIG_SPL_BUILD
-#define CONFIG_HW_WATCHDOG
-#else
+#ifndef CONFIG_SPL_BUILD
#undef CONFIG_HW_WATCHDOG
#undef CONFIG_DESIGNWARE_WATCHDOG
#endif
- CONFIG_SYS_SPL_MALLOC_SIZE)
/* SPL SDMMC boot support */
-#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION 1
#define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot.img"
#endif /* __CONFIG_SOCFPGA_SOC64_COMMON_H__ */