/*
* Hardware drivers
*/
-#define CONFIG_NET_MULTI
#define CONFIG_CS8900 /* we have a CS8900 on-board */
#define CONFIG_CS8900_BASE 0x18800300
#define CONFIG_CS8900_BUS16 /* follow the Linux driver */
#define CONFIG_SERIAL1 1 /* we use SERIAL 1 on SMDK6400 */
#define CONFIG_SYS_HUSH_PARSER /* use "hush" command parser */
-#ifdef CONFIG_SYS_HUSH_PARSER
-#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
-#endif
#define CONFIG_CMDLINE_EDITING
#define CONFIG_SYS_HZ 1000
-/* valid baudrates */
-#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
-
-/*-----------------------------------------------------------------------
- * Stack sizes
- *
- * The stack sizes are set up in start.S using the settings below
- */
-#define CONFIG_STACKSIZE 0x40000 /* regular stack 256KB */
-
/**********************************
Support Clock Settings
**********************************
#define CONFIG_SYS_NAND_ECCSIZE CONFIG_SYS_NAND_PAGE_SIZE
/* Number of ECC bytes per OOB - S3C6400 calculates 4 bytes ECC in 1-bit mode */
#define CONFIG_SYS_NAND_ECCBYTES 4
-/* Number of ECC-blocks per NAND page */
-#define CONFIG_SYS_NAND_ECCSTEPS (CONFIG_SYS_NAND_PAGE_SIZE / CONFIG_SYS_NAND_ECCSIZE)
/* Size of a single OOB region */
#define CONFIG_SYS_NAND_OOBSIZE 64
-/* Number of ECC bytes per page */
-#define CONFIG_SYS_NAND_ECCTOTAL (CONFIG_SYS_NAND_ECCBYTES * CONFIG_SYS_NAND_ECCSTEPS)
/* ECC byte positions */
#define CONFIG_SYS_NAND_ECCPOS {40, 41, 42, 43, 44, 45, 46, 47, \
48, 49, 50, 51, 52, 53, 54, 55, \