/* setting board specific options */
#define CONFIG_SYS_AUTOLOAD "yes"
-#define CONFIG_RESET_TO_RETRY
/* The LED PINs */
#define CONFIG_RED_LED AT91_PIN_PA9
#define CONFIG_SYS_NAND_ENABLE_PIN AT91_PIN_PC14
#define CONFIG_SYS_NAND_READY_PIN AT91_PIN_PC13
-/* general purpose I/O */
-#define CONFIG_ATMEL_LEGACY /* required until (g)pio is fixed */
-#define CONFIG_AT91_GPIO_PULLUP 1 /* keep pullups on peripheral pins */
-
/* serial console */
#define CONFIG_USART_BASE ATMEL_BASE_DBGU
#define CONFIG_USART_ID ATMEL_ID_SYS
*
*/
#define CONFIG_RMII /* use reduced MII inteface */
-#define CONFIG_NET_RETRY_COUNT 20 /* # of DHCP/BOOTP retries */
-#define CONFIG_AT91_WANTS_COMMON_PHY
/* BOOTP and DHCP options */
-#define CONFIG_BOOTP_BOOTFILESIZE
-#define NFSBOOTCOMMAND \
- "setenv autoload yes; setenv autoboot yes; " \
- "setenv bootargs ${basicargs} ${mtdparts} " \
- "root=/dev/nfs ip=dhcp nfsroot=${serverip}:/srv/nfs/rootfs; " \
- "dhcp"
#if !defined(CONFIG_SPL_BUILD)
/* USB configuration */
#endif
/* General Boot Parameter */
-#define CONFIG_BOOTCOMMAND "run flashboot"
#define CONFIG_SYS_CBSIZE 512
/*