* SDRAM: 1 bank, 64 MB, base address 0x20000000
* Already initialized before u-boot gets started.
*/
-#define CONFIG_NR_DRAM_BANKS 1
#define CONFIG_SYS_SDRAM_BASE ATMEL_BASE_CS1
#define CONFIG_SYS_SDRAM_SIZE (64 * SZ_1M)
ROUND(3 * CONFIG_ENV_SIZE + (4 * SZ_1M), 0x1000)
/* NAND flash settings */
-#define CONFIG_NAND_ATMEL
#define CONFIG_SYS_MAX_NAND_DEVICE 1
#define CONFIG_SYS_NAND_BASE ATMEL_BASE_CS3
#define CONFIG_SYS_NAND_DBW_8
#define CONFIG_SYS_NAND_ENABLE_PIN AT91_PIN_PC14
#define CONFIG_SYS_NAND_READY_PIN AT91_PIN_PC13
-#define CONFIG_MTD_DEVICE
-
/* general purpose I/O */
#define CONFIG_ATMEL_LEGACY /* required until (g)pio is fixed */
#define CONFIG_AT91_GPIO /* enable the GPIO features */
"root=/dev/nfs ip=dhcp nfsroot=${serverip}:/srv/nfs/rootfs; " \
"dhcp"
-/* Enable the watchdog */
-#define CONFIG_AT91SAM9_WATCHDOG
-#if !defined(CONFIG_SPL_BUILD)
-#define CONFIG_HW_WATCHDOG
-#endif
-#define CONFIG_AT91_HW_WDT_TIMEOUT 15
-
#if !defined(CONFIG_SPL_BUILD)
/* USB configuration */
#define CONFIG_USB_ATMEL
#define CONFIG_SYS_USB_OHCI_MAX_ROOT_PORTS 2
/* USB DFU support */
-#define CONFIG_MTD_DEVICE
-#define CONFIG_MTD_PARTITIONS
#define CONFIG_USB_GADGET_AT91